LinHES Forums http://forum.linhes.org/ |
|
write_file, and read_fragment failures? http://forum.linhes.org/viewtopic.php?f=1&t=20219 |
Page 1 of 1 |
Author: | yaplej [ Mon Aug 10, 2009 2:08 am ] |
Post subject: | write_file, and read_fragment failures? |
Hello, I am trying to install R6.00.08 on an older machine to use as a MBE only. Durring the install I get a lot of these errors: Code: write_file: failed to read data block 0xHEX
read_fragment: failed to read fragment # It seems to ignore those erros, and keeps on going. After it finishes though the system does not boot. I thought it could be a bad drive so I fired up UBCD and ran the Hard Drive Fitness Test. The drive passed several times. I thought it could be the disk so I downloaded and made a new one, but still no change. Perhaps R6 just does not like the older hardware. Dual P3 1GHz CPU's Asus CUR-DLS Motherboard 2GB PC133 ECC Memory 30GB IDE boot driver 4x 160GB SATA on SuperMicro 8x SATA card |
Author: | Greg Frost [ Mon Aug 10, 2009 5:45 am ] |
Post subject: | |
Could be a bad cd drive or burner or media or media incompatibility. |
Author: | yaplej [ Mon Aug 10, 2009 6:42 pm ] |
Post subject: | |
Actually I think its the same problem I had with a Dell PE1550 that also uses a ServerWorks chipset. The installer boots, but when trying to access the IDE drive to install the system it fails to correctly access the drive. I had the same problem with Ubuntu 8.04. I think the it was fixed in RHEL, but not sure if that also made it to CentOS. I am going to give that a try, and see if CentOS will install. In the meantime I have another motherboard without the ServerWorks chips that I can try to do the installation on, and then move the drive into this system. |
Page 1 of 1 | All times are UTC - 6 hours |
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |