LinHES Forums

LIRC and two serial ports
Page 1 of 1

Author:  daveycanuck [ Sun Nov 08, 2009 8:31 pm ]
Post subject:  LIRC and two serial ports

I'm struggling with an installation issue that I haven't been able to get past. I have installed LinHES v6.00.1 without any real difficulty but am having trouble getting my serial IR blaster and my serial IR reciever to work at the same time. I can get one or the other to work but LIRC seems to only want to recognize devices on ttyS0. LinHES seems to give me the ability to have a serial blaster on ttyS0 and a remote on ttyS1 but no matter what I try I can't get them both to work simultaneously. Any suggestions would be appreciated.
I'm not sure what data to post but if there are config files or other info that would be useful just let me know and I'll post it up here.

Author:  jams [ Thu Nov 12, 2009 10:15 pm ]
Post subject: 

open a flyspray ticket. I am trying to make time to fix some other things with lirc so might as well through this on the pile.

Author:  jams [ Thu Nov 12, 2009 10:16 pm ]
Post subject: 

also attach /etc/systemconfig for both situations. Either put it in the ticket or you can email them directly to me.

Author:  cliffsjunk [ Thu Nov 19, 2009 11:46 am ]
Post subject: 

At times I have had to fiddle my /var/lib/setserial/autoserial.conf
to change the /dev/ttyS0 line to:
/dev/ttyS0 uart none

to get my lirc to work. Perhaps you need a line for ttyS1 as well.


Page 1 of 1 All times are UTC - 6 hours
Powered by phpBB® Forum Software © phpBB Group