LinHES Forums • View topic - How to re-run startup install

Board index KnoppMyth Installation

All times are UTC - 6 hours

How to re-run startup install

Page 1 of 1

[ 3 posts ]

Print view

Previous topic Next topic

Author

Message

douglaing

Post subject: How to re-run startup install

Posted: Fri May 06, 2005 12:04 am

Joined: Sun Feb 20, 2005 11:29 am

Posts: 19

Location: Garden Grove, CA

I just loaded R12 with some problems getting a new PRV-350 card to work without a green purple screen. Now that I have fix this problem I put my second card back into the system and restarted expecting to see the startup configuration because it saw the new card but I just starts Mythtv. How do I force the config screen on startup so I can setup the second card.

By the way the system has the 2nd card listed during the boot process.

I have looked for a thread on how to force the config screen but have not ben able to find.

_________________
Doug Laing
doug@laingelectronics.com
Hotmail/Trillian (doug-laing@hotmail.com)

Top

Greg Frost

Post subject:

Posted: Fri May 06, 2005 1:06 am

Joined: Mon May 10, 2004 8:08 pm

Posts: 1891

Location: Adelaide, Australia

Code:

mythtv-setup

as the mythtv user in an xterm

Top

douglaing

Post subject: That worked

Posted: Fri May 06, 2005 11:47 am

Joined: Sun Feb 20, 2005 11:29 am

Posts: 19

Location: Garden Grove, CA

That worked after I fugured out how to exit Mythtv and start a xwindow term session. New at this stuff.

_________________
Doug Laing
doug@laingelectronics.com
Hotmail/Trillian (doug-laing@hotmail.com)

Top

Page 1 of 1

[ 3 posts ]

Board index KnoppMyth Installation

All times are UTC - 6 hours

Who is online

Users browsing this forum: No registered users and 2 guests

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum