Have set up pvr150 blaster that works but when I go to Myth setup to add in the channel change script and set the channel to 3
When I restart Myth the pvr tunes to channel 4
I go back and take everything out and it tunes properly IE 3 is 3, 4 is 4.

Strange so I leave the tuner on 3 and go back into setup reset everything reboot and once again the box tunes to channel 4

Any ideas?

Craig

there is a setting to select the initial channel that the tune should be set to...actually I see two.

Preset tuner to channel:

and

Starting Channel:

are they set to 3?

Do channel changes get logged to the mythtv.log file? maybe a clue is in there

_________________
R5F1 - Dell P4 2.4Ghz 500MB - PVR250 x 2 - GeForce FX 5200 - Onboard sound/NIC 80GB ATA/250GB ATA/400GB SATA

Yes I set them both to 3 and yet i get channel 4
I go back into the setup and the settings appear to have held.

I will check the logs but the irblaster is sending out a signal on the channel change.

I have never used the blaster....is it a shell script? are there commands, settings in the script that are set to channel 4

_________________
R5F1 - Dell P4 2.4Ghz 500MB - PVR250 x 2 - GeForce FX 5200 - Onboard sound/NIC 80GB ATA/250GB ATA/400GB SATA