| LinHES Forums http://forum.linhes.org/ |
|
| R5A12 -> R5A15 upgrade, DVB SCAN not working http://forum.linhes.org/viewtopic.php?f=11&t=4332 |
Page 1 of 1 |
| Author: | Nigel [ Thu Apr 28, 2005 7:49 pm ] |
| Post subject: | R5A12 -> R5A15 upgrade, DVB SCAN not working |
Howdy. Ive just upgraded my Mythbox to R5A15. I have a P-IV 1.7, SIS mobo, and 2 * K-world/V-tream DVB-T Cards To get this working under 5A12 I had to compile a new kernel with patches so that it would recognise the Connexant DVB. After that it has been working a treat. HOWEVER... I have just upgraded to R5A15. Figured Id do a complete install just because that way nothing I did would affect it. It recognises my DBV cards fine. I can add them to setup, set up the EPG etc. But I Cant Scan. It appears to hang at either 5 or 10%. I can cancel it, but Scan will not complete. If I look at the Console window It Tunes, Locks, and then stops. I can tune fine using tzap etc. Any Ideas? Thanks Nigel |
|
| Author: | Greg Frost [ Thu Apr 28, 2005 9:02 pm ] |
| Post subject: | |
I found with my DVICO FusionHDTV, it wouldn't scan unless I entered the transport frequency **and** bandwidth. You could try that. |
|
| Author: | Nigel [ Thu Apr 28, 2005 11:53 pm ] |
| Post subject: | |
I have done this. Ive actually added all of them (Learned that with 5A12) It actually does scan, and lock on first channel, then litterally stops. Nigel |
|
| Author: | Greg Frost [ Fri Apr 29, 2005 12:13 am ] |
| Post subject: | |
Have you tried scanning transports individually. I live in an area of Adelaide that is shadowed from the main transmitter. As a result I receive a repeated signal, so my frequencies are different to the normal frequencies for each channel. If I try to scan all transports, it seems to attempt to tune to one of the standard frequencies (even though I did not enter that frequency). I assume it gets this information from the first transport it tunes to somehow, but as a result, it just hangs. I got around this by scanning the transports that I had entered one at a time. |
|
| Author: | Nigel [ Fri Apr 29, 2005 1:36 am ] |
| Post subject: | |
I sure have. Like I said : I had it working with 5A12. All of the steps are the same : I had to make sure that the bandwidth was specified. This just stops once it locks onto a channel. A12 scanned for all channels Nigel |
|
| Author: | Greg Frost [ Fri Apr 29, 2005 3:17 am ] |
| Post subject: | |
Oh well, sorry I couldn't help. Those were the two things I had trouble with. |
|
| Author: | nigelpearson [ Sun May 01, 2005 6:09 pm ] |
| Post subject: | |
Egads! Who let another Nigel in here 
Nige, I am not familiar with that card, but you may have to wait a while for its updated drivers to work their way into an official kernel, and in the mean time rebuild the kernel in R5A15 and any future alpha releases. Sorry. |
|
| Page 1 of 1 | All times are UTC - 6 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|