| LinHES Forums http://forum.linhes.org/ |
|
| how to set default capture card http://forum.linhes.org/viewtopic.php?f=11&t=8923 |
Page 1 of 1 |
| Author: | seandiggity [ Sat Mar 11, 2006 7:28 am ] |
| Post subject: | how to set default capture card |
I have two capture cards installed (a WinTV 150 and WinTV Go 190) and was wondering how to set the WinTV 150 to /dev/video0 and make the Go 190 /dev/video1 I know it's a newbie question, but I tried switching the PCI slots the cards were in and the order didn't change. The WinTV Go, which is currently /dev/video0, has crappier colors and when I go to "Watch TV" it always defaults to that card (I have to press Y to change it). Thanks in advance! |
|
| Author: | tjc [ Sat Mar 11, 2006 9:32 am ] |
| Post subject: | |
Increase the "input preference" value for the better card in mythtv-setup under "4. Input Connections". |
|
| Author: | seandiggity [ Sat Mar 11, 2006 1:35 pm ] |
| Post subject: | all set |
Awesome. That worked; I feel a bit dumb... |
|
| Page 1 of 1 | All times are UTC - 6 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|