Hi,
I have managed to get my IR blaster from
www.irblaster.info working with one of my ExpressVu 3100 (Similar to Dish 301) receivers using the tutorial
http://losdos.dyndns.org:8080/public/my ... _LIRC.html. To do this I used the ledxmitd.conf file based on the remote deffinition at
http://lirc.sourceforge.net/remotes/dishnet/SAT_301.
So far all is good, so I want to add a second receiver, and make use of the second receiver on my PVR-500.
I scrolled down to the section in the above tutorial to the section for using multiple receivers. I generated the raw remote for for my second remote address (9) and pased it into the /etc/ledxmitd.conf file below the original one, and called the remote "31009".
I also took the change_chan.sh script and changed the name to change_chan2.sh and changed the remote name from 3100 to 31009.
At this point, after rebooting or restarting the daemon I should be able to change channels on my second receiver, but no go. Receiver 1 (3100) is working fine, but the new receiver isn't (31009).
I have created new ledxmitd.conf where both remote profiles are in rew format, generated by the JVC_RAW script. This caused both to stop working at all.
When I send a command to the change_chan2.sh script here is the response I get:
Code:
#/usr/local/bin/change_chan2.sh 500
/usr/local/lirc-ledxmit/bin/ledxmit-irsend: command failed: SEND_ONCE 31009 5
/usr/local/lirc-ledxmit/bin/ledxmit-irsend: transmission failed
/usr/local/lirc-ledxmit/bin/ledxmit-irsend: command failed: SEND_ONCE 31009 0
/usr/local/lirc-ledxmit/bin/ledxmit-irsend: transmission failed
/usr/local/lirc-ledxmit/bin/ledxmit-irsend: command failed: SEND_ONCE 31009 0
/usr/local/lirc-ledxmit/bin/ledxmit-irsend: transmission failed
versus what happend when I do the original script.
Here is the content of the change_chan2.sh script:
Code:
#!/bin/sh
REMOTE_NAME=31009
for digit in $(echo $1 | sed -e 's/./& /g'); do
/usr/local/lirc-ledxmit/bin/ledxmit-irsend SEND_ONCE $REMOTE_NAME $digit
sleep 0.3 # note, you may have to tweak the interdigit delay up a bit, depending on your DISH receiver model
done
The only thing that I have been unable to figure out is how to use a non-raw file similar to the original one I used for the first receiver, but with a remote address of 9. I have been unable to figure out is how to modify that file so that it sends address 9 for the second remote.
Any thoughts on what could be going on?
Cheers
Victor
View unanswered posts
View active topics
KnoppMyth 
Print view
Previous topic Next topic 
LinHES Home
Board index
FAQ
Search
Login 
Register
