Yeah, leave it running and go to bed. It can take a lot of tests to turn up memory issues. If the error count is still 0 in the morning you're probably fine on that count.

HO. LE. cabbage....

I took out my Lite-on DVD burner, and its INSTALLING!! OMG, hope hope hope!

I got everything installed and stable, so heres my question. When I go into WATCH TV, my screen flicks for a milisecond, then comes back to the main screen. I installed the tuners and sources in myth setup, and made sure I had two different names, but when I go to scan for channels, it finds nothing. I am using a PVR 500 card. As well as a PVR-150 now with the blaster and the remote. After I had issues in setting this up, i shut down, pulled out the 150, and tried to set up the 500 in the case by itself, but still, when it does a channel scan, it finds nothing.

Yes the cable is connected to the wall, yes i checked it with another television, and yes its connected to the correct RF plug on the card. I did tell it to use CABLE-IRC, as that is the signal provided in this area, and I told it to pull from TUNER. Suggestions?

ALSO, if i ran setup under "TV" is it safe to hook up my television now, even though i did my setup on a regular monitor?

IM SO CLOSE!

Start another thread.

_________________
cesman

When the source is open, the possibilities are endless!