LinHES Forums
http://forum.linhes.org/

Problem running CD for R5C7 and/or R5B7
http://forum.linhes.org/viewtopic.php?f=14&t=10184
Page 1 of 1

Author:  jim70739 [ Wed May 24, 2006 10:47 am ]
Post subject:  Problem running CD for R5C7 and/or R5B7

I have one Knoppmyth up and running and want to set another box up to debug all/some of my mistakes with the first one plus add some later "goodies". I am by no stretch an expert.

I have an EPoX EP-8KDA71
SD CARD Creative SB0570 Audigy SE OE
Segate 300 & 160 HDDs
VGA EVGA GF6200 128-A8-N339 video card
no floppy drive and turned off in bios
AMD 3400
Lite-On SHW-160P6S DVD

I cannot get the CD to run, everything stops at the start of boot up and give me:
Welcome to KNOPPIX Live-On-CD
Probing SCSI...aicxxx_CAUTION.0
It totally shuts down. I don't think I have any SCSI hardware but I am not an expert. The raid part of the board is turned off in bios.
Could someone tell me what this message is telling me and where to look to correct.
Looked in FAQ and tried the one solution it had but my kernal could not find the noscsi module.
:(

Author:  tjc [ Wed May 24, 2006 4:26 pm ]
Post subject: 

When the CD boots and asks for boot options say:
Code:
expert tv testcd

When it asks about SCSI drivers answer "n" for none.

Author:  jim70739 [ Fri May 26, 2006 2:45 pm ]
Post subject: 

Thank you!

Page 1 of 1 All times are UTC - 6 hours
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/