I am experiencing the same issue. I had to add snd_cmipci to /etc/modules
This fixed it for me. While in that file, I also commented out '#' snd_via82xx
I hope this helps you out.
| LinHES Forums http://forum.linhes.org/ |
|
| Upgraded to R5D1, now have bizzare sound issue http://forum.linhes.org/viewtopic.php?f=14&t=11464 |
Page 1 of 1 |
| Author: | synchro [ Tue Sep 05, 2006 10:57 pm ] |
| Post subject: | Upgraded to R5D1, now have bizzare sound issue |
I have searched and I can not figure out how to fix this issue. Forsome reason in R5D1 it finds 2 sound cards. I have the onboard VIA card disabled, but it still gets detected and is setup as my main sound card. When I go to alsamixer it shows that card and not my card I want to use. I run Alsaconf, and it finds my Hecrules fortissmo card and installs it. I then have to do a modprob snd-cs46xx and then go into alsamixer and reneable my optical out, resart the mythfront end. Sound works. But as soon as I reboot everything goes back to the VIA sound card. To get it to work I have to that all again. How can I get knoppmyth to only load my snd-cs46xx driver? I have added the modprobe snd-cs46xx to the bootmisc.sh, but that didnt change anything. On a side note, for some reason I cant get this version to see my previous recordings, but that is minor. I can work on that once my sound works. Anyone have a link to an article that can help me, or have the fix? Thanks Mike |
|
| Author: | jigawho [ Wed Sep 06, 2006 9:59 am ] |
| Post subject: | |
I had the same issue and ended up going back to R5C7 becasue of this and other issues with the new version. I did figure out a workaround for my setup (Chaintech av-710) which was to change the myth sound output to adsp1 and then edit my asound.conf file so that all references to hw0,0 went to hw1,0 . That gave me spdif output in both xine and myth. I looked into trying to change the order of the soundcards, but found that this fix was easier. |
|
| Author: | sjerome [ Tue Sep 12, 2006 9:19 pm ] |
| Post subject: | |
I am experiencing the same issue. I had to add snd_cmipci to /etc/modules This fixed it for me. While in that file, I also commented out '#' snd_via82xx I hope this helps you out.
|
|
| Author: | sjerome [ Wed Sep 13, 2006 9:32 am ] |
| Post subject: | My other post regarding this issue |
Here is the link to my other post, with my complete solution. Best of Luck. 
http://mysettopbox.tv/phpBB2/viewtopic.php?t=11583 |
|
| Author: | synchro [ Tue Sep 19, 2006 9:52 pm ] |
| Post subject: | THANK YOU |
I followed your Instructions and it works. Thank you very much. now just to get my screen configured and I am back to where I was a few weeks ago Mike |
|
| Page 1 of 1 | All times are UTC - 6 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|