Hiya all - I just upgraded to R5D1 and my lirc/irblaster setup is a bit hosed - I had to point lirc config to lirc1 which was new - but that works - the irblasterd and lircd are running:

/usr/sbin/lircd --driver=default --device=/dev/lirc1
root 21922 1 0 18:05 ? 00:00:00 /usr/sbin/irblasterd --driver=default --device=/dev/irblaster --pidfile=/var/run/irblasterd.pid --output=/dev/irblasterd /etc/irblaster/irblasterd.conf

But - when you change channels you see:

BUG: using smp_processor_id() in preemptible [00000001] code: irblasterd/21922
caller is lirc_ioctl+0xa4/0x370 [lirc_serial]
<c02fa777> debug_smp_processor_id+0x87/0xa0 <e0dc5174> lirc_ioctl+0xa4/0x370 [lirc_serial]
<e115a00a> irctl_ioctl+0x17a/0x1e0 [lirc_dev] <c0182fa6> do_ioctl+0x46/0x70
<c0183143> vfs_ioctl+0x53/0x1c0 <c018330d> sys_ioctl+0x5d/0x70
<c0103177> syscall_call+0x7/0xb

2.6.17-chw-8 #1 SMP PREEMPT


processor : 0
vendor_id : AuthenticAMD
cpu family : 6
model : 8
model name : AMD Athlon(tm)


modinfo lirc_serial
filename: /lib/modules/2.6.17-chw-8/misc/lirc_serial.ko
description: Infra-red receiver driver for serial ports.
author: Ralph Metzler, Trent Piepho, Ben Pfaff, Christoph Bartelmus
license: GPL
vermagic: 2.6.17-chw-8 SMP preempt mod_unload 586 gcc-3.4
depends:
parm: debug:Enable debugging messages (bool)
parm: softcarrier:Software carrier (0 = off, 1 = on) (bool)
parm: txsense:Sense of transmitter circuit (0 = active high, 1 = active low ) (bool)
parm: sense:Override autodetection of IR receiver circuit (0 = active high, 1 = active low ) (bool)
parm: share_irq:Share interrupts (0 = off, 1 = on) (bool)
parm: irq:Interrupt (4 or 3) (int)
parm: io:I/O address base (0x3f8 or 0x2f8) (int)
parm: type:Hardware type (0 = home-brew, 1 = IRdeo, 2 = IRdeo Remote, 3 = AnimaX, 4 = IgorPlug (int)


Only other bug I'm working on from the upgrade is; manual record and live tv work good - but scheduled recordings blank ..

Any thoughts appreciated!


Xavier