Fresh install of R5F27 on a Dell optiplex gx260
The capture card is a Kworld Global TV Terninator (guess it's the same or similar to the ones mentioned previously). The card was not detected automatically (unlike the previous poster's card), so I added the following to a file called saa7134 in /etc/modprobe.d/
options saa7134 card=65 tuner=54
Got the directions from here
http://www.mythtv.org/wiki/index.php/KW ... Terminator
& I see the previous poster did similar.
Also placed lines in /etc/init.d/rc.local as previous poster did,
Getting video OK, but no sound.
Doing a "ls /dev/dsp*" only shows /dev/dsp, this is the built in soundcard.
dmesg shows:
saa7130/34: v4l2 driver version 0.2.14 loaded
saa7133[0]: found at 0000:01:07.0, rev: 209, irq: 17, latency: 64, mmio: 0xff8ff800
saa7133[0]: subsystem: 17de:7136, board: V-Stream Studio TV Terminator [card=65,insmod option]
saa7133[0]: board init: gpio is 40
input: saa7134 IR (V-Stream Studio TV as /class/input/input0
saa7133[0]: i2c eeprom 00: de 17 36 71 ff ff ff ff ff ff ff ff ff ff ff ff
saa7133[0]: i2c eeprom 10: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff
saa7133[0]: i2c eeprom 20: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff
saa7133[0]: i2c eeprom 30: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff
saa7133[0]: i2c eeprom 40: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff
saa7133[0]: i2c eeprom 50: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff
saa7133[0]: i2c eeprom 60: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff
saa7133[0]: i2c eeprom 70: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff
tuner 1-004b: chip found @ 0x96 (saa7133[0])
saa7133[0]: registered device video0 [v4l2]
saa7133[0]: registered device vbi0
saa7133[0]: registered device radio0
saa7134 OSS driver for DMA sound loaded
Modules linked in: saa7134_oss ipv6 af_packet fuse tsdev usbhid pcmcia yenta_socket rsrc_nonstatic pcmcia_core video thermal sbs processor i2c_ec fan container button battery ac unionfs sbp2 ohci1394 ieee1394 usb_storage ohci_hcd cx88_vp3054_i2c cx8802 cx88xx saa7134_dvb video_buf_dvb tda1004x nvram dvb_bt8xx dvb_core bt878 bttv i2c_algo_bit btcx_risc tveeprom firmware_class evdev tuner tea5767 tda8290 tuner_simple mt20xx saa7134 intel_agp video_buf compat_ioctl32 ir_kbd_i2c ir_common agpgart videodev v4l2_common v4l1_compat ehci_hcd shpchp pci_hotplug i2c_i801 i2c_core snd_intel8x0 snd_ac97_codec snd_ac97_bus snd_pcm_oss snd_mixer_oss snd_pcm snd_timer snd soundcore snd_page_alloc serio_raw uhci_hcd usbcore 8250_pnp 8250 serial_core parport_pc parport
EIP is at saa7134_oss_init1+0x21/0x150 [saa7134_oss]
[<d0c9b9e0>] saa7134_oss_irq+0x0/0x8a [saa7134_oss]
[<d0c9b152>] oss_device_init+0x12/0xa0 [saa7134_oss]
[<d0c9b636>] saa7134_oss_init+0x66/0xc0 [saa7134_oss]
EIP: [<d0c9b011>] saa7134_oss_init1+0x21/0x150 [saa7134_oss] SS:ESP 0068:ca331ea0
Not sure what "EIP" means.
lspci -v shows:
01:07.0 Multimedia controller: Philips Semiconductors SAA7133/SAA7135 Video Broadcast Decoder (rev d1)
Subsystem: KWorld Computer Co. Ltd. Unknown device 7136
Flags: bus master, medium devsel, latency 64, IRQ 17
Memory at ff8ff800 (32-bit, non-prefetchable) [size=2K]
Capabilities: [40] Power Management version 2
arecord -l shows:
**** List of CAPTURE Hardware Devices ****
card 0: I82801DBICH4 [Intel 82801DB-ICH4], device 0: Intel ICH [Intel 82801DB-ICH4]
Subdevices: 0/1
Subdevice #0: subdevice #0
card 0: I82801DBICH4 [Intel 82801DB-ICH4], device 1: Intel ICH - MIC ADC [Intel 82801DB-ICH4 - MIC ADC]
Subdevices: 1/1
Subdevice #0: subdevice #0
card 0: I82801DBICH4 [Intel 82801DB-ICH4], device 2: Intel ICH - MIC2 ADC [Intel 82801DB-ICH4 - MIC2 ADC]
Subdevices: 1/1
Subdevice #0: subdevice #0
card 0: I82801DBICH4 [Intel 82801DB-ICH4], device 3: Intel ICH - ADC2 [Intel 82801DB-ICH4 - ADC2]
Subdevices: 1/1
Subdevice #0: subdevice #0
I found a detailed page on saa7134
http://www.linuxtv.org/v4lwiki/index.php/Saa7134-alsa
I tried saa7134-alsa, but this hung the system on reboot.
I've successfully set up Knoppmyth with saa713X cards previously, but this capture card does not have an audio out on the back panel, so I assume the driver needs to grab the audio directly from the card.
Alsa is supposed to be able to do this, guess I would prefer to get saa7134-alsa working over saa7134-oss, but any audio is better than none.
Anyone gotten this card working with R5F27?