LinHES Forums
http://forum.linhes.org/

KnoppMyth Frontend,Slave with MythDora All in One f&b
http://forum.linhes.org/viewtopic.php?f=14&t=16270
Page 1 of 1

Author:  littleman09z [ Wed Aug 29, 2007 9:41 pm ]
Post subject:  KnoppMyth Frontend,Slave with MythDora All in One f&b

Hi, right now I have a Mythdora 4.0 all in one box with 2 pvr 250s and a 1.2tb lvm setup. I added a knoppmyth box(auto install) and then followed the guide on knoppmythwiki to setup it up as a slave. I partially got that working. i can now watch all my recordings and I have the box setup to do all the comm flagging.

The couple questions I have are,
1) Looking at mythweb it shows that Host: master is doing the commerical flagging. How can I go about changing this. I setup my hostname as smythtv in the basic questions it asked
2) is is possible to use myth2ipod installed on knoppmyth and then use nfs and have the feeds through the mythdora box hooked with mythweb


thanks

zach

Author:  cecil [ Thu Aug 30, 2007 10:02 am ]
Post subject: 

Sorry I have the time to give complete details:

1) Yes, this should be possible. Simply allow the SBE to run jobs and disallow the MBE.

2) I don't know. But, I see no reason why not. You have the source with you. ;)

Author:  littleman09z [ Thu Aug 30, 2007 2:08 pm ]
Post subject: 

when i disabled the mater and set the slave to do it. when i awoke this morning the slave was on the same job the night before stuck at 99% saying it was doing 36 fps. with a job queue of 6 when its usually of zero. i will re put the settings again tonight and see how well it does again.

does anyone know how to change the name mythweb uses to tell what "host" is doing the flagging jobs?

Page 1 of 1 All times are UTC - 6 hours
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/