| LinHES Forums http://forum.linhes.org/ |
|
| nuvexport on R12 everything disabled http://forum.linhes.org/viewtopic.php?f=14&t=4500 |
Page 1 of 1 |
| Author: | douglaing [ Mon May 09, 2005 2:26 pm ] |
| Post subject: | nuvexport on R12 everything disabled |
I followed the how to for setup of nuvexport but when I run all the options in th menu except "Export to .nuv and .sql" have (disabled) behind them. If I try for example option 9 "Mpeg2->Mpeg2 cut only" I get "You need livemux & avidemux2 to use this". The how to did not talk about them and I can not find much here about them. I have the video going to TV using A PRV-350 so I cant run nuv2dvd because it needs 800x600 screen resolution. Any help ???? |
|
| Author: | douglaing [ Mon May 09, 2005 9:29 pm ] |
| Post subject: | A little furthur but still not there |
I found a Howto on knoppymthwiki "NuvexportMPEGcut" has how to install "lvempeg" & "avidemux2". Well the install of "lvempeg" went ok, but the "avidemux2" would not install, It seems to go ok but at the verry end of "make install avidemux2" I get the following error. > make[1]: Leaving directory `/home/mythtv/avidemux-2.0.38rc3' > make: *** No rule to make target `avidemux2'. Stop. -bash: command substitution: line 1: unexpected EOF while looking for matching `'' -bash: command substitution: line 3: syntax error: unexpected end of file -bash: make[2]:: command not found root@mythtv:/home/mythtv/avidemux-2.0.38rc3# |
|
| Author: | douglaing [ Mon May 09, 2005 9:30 pm ] |
| Post subject: | followup |
Also I tried on "rc1", "rc2", and "rc3" and got the same error on all three. |
|
| Author: | entourage [ Mon Sep 19, 2005 10:02 am ] |
| Post subject: | |
I know this is an old post, but I was hoping someone would have a suggestion or solution. I too am having issues where in R5A15.1 all of the nuvexport options are disabled (except "Export to .nuv and .sql) I read at knoppmythwiki.org in the how-to about upgrading and have done that successfully, however everything is still disabled. Thanks in advance! |
|
| Author: | entourage [ Mon Sep 19, 2005 8:49 pm ] |
| Post subject: | |
Follow-up: Upgraded ffmpeg and mpeg2dec via the knoppmythwiki here: http://www.knoppmythwiki.org/index.php? ... thStreamTV I then had most of the options enabled, however when I try to encode to Divx, it says it completes, however I can't find my file. I've searched several places on the myth install and can't locate it. I've used the [.] location when it prompts. I even tried [/home/mythtv] Any suggestions? edit: Trying to encode to DVD results in this error unknown input or output format: dvd |
|
| Page 1 of 1 | All times are UTC - 6 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|