I have a cable box set up wiht an IR blaster. I have the remote config downloaded from http://lirc.sourceforge.net/remotes/mot ... gitalCable

the change_channel.sh script is working fine manually, but when the script changes the channel, the"OK" button must be pressed for the cable box to accept and change to the new channel. My cable bix (DCT2224) has the OK button on the remote, but this listing of IR codes doesn't have the hex code for the OKy button...

So, I went to visit Mr. Google and he told me that:

0000 006D 0000 0002 0000 00AA 0000 0055 0000 0055 0000 0055 0000 0055 0000 00AA 0000 0055 0000 0055 0000 0055 0000 0055 0000 0055 0000 0055 0000 0055 0000 00AA 0000 00AA 0000 00AA 0000 00AA 0000 0489 0000 0055 0000 0D03

is the pronto hex format. Whatever the hell that is...
http://www.remotecentral.com/cgi-bin/co ... s/dct2224/ (can be seen here)


I need something like:
OK 0x00000000000077F8

that the other remotes have... although none of the other motorola's seem to work.

Anyone have any idea how to convert this, or more specifically the complete listing of buttons?

If you go into your dct's Menu then go to setup then go to guide then look for auto tune and turn it on. If your software is the same as mine then after the box recieves the channel number if no other entries are recieved in a couple of seconds it will change.

Craig