Ok specs as follows
Mobo Asus A7V8X-X
Proc - Athlon 2400XP
RAM - 512MB
Video - Asus FX5200
HD - 80Gb and 120 GB
Knoppmyth - R5A26
Tuner 1 - pvr 500 - used for viewing and recording
Tuner card 2 - Win TV go - used for remote control only
I have used LVM to join the 2 hard disks to give me 180Gb for /myth. that works ok. Issue I have with it is more a cosmetic one it now shows it looking through every other drive definition when starting eg /dev/SDA9... is there any way to edit the config to stop it looking at them (im still a little fresh at linux)
Major issue Im having is with my wireless NIC.
I am using ndiswrapper and initially on install it works and I can do mythfilldatabase. After first reboot though It loads the ndsiwrapper and runs dhclient successfully and gets its IP address as it should but then as the boot up process continues it looks as if it resets ndiswrapper and the usb ports. I have had it occasionally (read 1 out of 5 or 6 reboots) where it will once again load ndiswrapper but not the dhclient but as I say this is only every 5 or 6 reboots. If I go in and attempt to do it manually it tells me that the driver is loaded (doesnt show hardware pressent though - the usb reconfigure perhaps???) tried modporbe -r ndiswrapper to remove then modprobe ndiswrapper. It works partially but doesnt seem to do as it should and no device is present on WLAN0.
Unfortunatly there is no way to get wired net to this area and I need to use wlan. Any help is most appreciated as R5A26 is working a dream otherwise. Other inconvenience is that I used to use R5A16 on different mobo and it would loose connectiuon every so often (reboot would fix) on the times I have had R5A26 running with the NIC it seems to do it also. My workaround has been to keep a SSH session to it and it keeps running.
HEEEEEEELP *grin* Steve
