The DVR & PVR 500 are two different cards... I had a quick google but didn't find much that helps
something mentioned it uses a connexant chip (the old ones use a brooktree? chip)
| LinHES Forums http://forum.linhes.org/ |
|
| No Signal, Hauppauge WinTV DVR 500 http://forum.linhes.org/viewtopic.php?f=14&t=8218 |
Page 1 of 1 |
| Author: | JimElNino [ Wed Feb 01, 2006 2:35 am ] |
| Post subject: | No Signal, Hauppauge WinTV DVR 500 |
Hey all Installed KnoppMyth, everything went fine, except I get no video when I try to watch tv, I used this as an install guide for the backend http://knoppmythwiki.org/index.php?page=PVR500DualTuner. Someone in that wiki mentioned having to update the firmware for the 500, is that a common thing for the newer ones? I just got this one this week. Any suggestions or help you could give would be greatly appreciated. Thanks -Jim |
|
| Author: | mad_paddler [ Wed Feb 01, 2006 5:32 am ] |
| Post subject: | |
The DVR & PVR 500 are two different cards... I had a quick google but didn't find much that helps something mentioned it uses a connexant chip (the old ones use a brooktree? chip)
|
|
| Author: | JimElNino [ Wed Feb 01, 2006 7:21 am ] |
| Post subject: | |
Ooops, that was a typo on my part, I do have the PVR 500 
I see that the period after that link was messing it up, here it is again, just in case http://knoppmythwiki.org/index.php?page=PVR500DualTuner |
|
| Author: | JimElNino [ Wed Feb 01, 2006 9:26 am ] |
| Post subject: | |
Well looking at some other posts I think I see the issue, I'll try installing the newest IVTV tonight and see if that works
|
|
| Author: | tjc [ Wed Feb 01, 2006 9:49 pm ] |
| Post subject: | |
You're a little light on details... What version of KnoppMyth are you installing? I believe R5A30.2 already has the latest IVTV (0.4.2) module. It does have a slightly older version of the firmware so upgrading that to the one recommend for 0.4.2 might help. |
|
| Author: | slacker [ Sun Feb 19, 2006 2:39 am ] |
| Post subject: | Thanks for the help |
Jim- Thanks for posting the fix for the Hauppauge 500 card.
I tried to install KnoppMyth R5A30.2 and had no video, then following the link you suggested, I was able to upgrade the drivers. http://knoppmythwiki.org/index.php?page=PVR500DualTuner Take care. |
|
| Author: | tjc [ Sun Feb 19, 2006 9:41 am ] |
| Post subject: | |
The 0.4.3 drivers are supposed to include that patch and the directions on the CompileIvtv page have been updated to install that version. |
|
| Page 1 of 1 | All times are UTC - 6 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|