LinHES Forums
http://forum.linhes.org/

Im trying to run knoppmyth, when i click on watch tv ....
http://forum.linhes.org/viewtopic.php?f=14&t=9309		 Page 1 of 1
Author:  aten2005 [ Mon Mar 27, 2006 2:39 pm ]
Post subject:  Im trying to run knoppmyth, when i click on watch tv ....
Im trying to run knoppmyth, when i click on watch tv, it says that it is not able to find an internet connection

http://www.eff.org/broadcastflag/cookbo ... shot-9.png

is it posible to run it with out one (internet connection)?

Thanks
Author:  aten2005 [ Mon Mar 27, 2006 2:41 pm ]
Post subject:  spects:
amd athlon 1800+
512 ram
40 gb hdd
radeon 9550
cd-rw
dvd rom


thanks :?:
Author:  Xsecrets [ Mon Mar 27, 2006 4:01 pm ]
Post subject: 
tv does not require an internet connection (at least not after you have your channel data downloaded) and I've never seen it complain about not having an "internet" connection. I have seen cannot connect to master backend. there is a big difference. Is your box all on one machine or are you trying to run frontend/backend on different machines (in which case a network connection is required)?
Author:  aten2005 [ Mon Mar 27, 2006 4:33 pm ]
Post subject: 
Xsecrets wrote:
(at least not after you have your channel data downloaded)



it has never been connected to the internet
Author:  elgordo123 [ Mon Mar 27, 2006 4:39 pm ]
Post subject: 
It it's never been connected to the internet, then more than likely it has no channels setup. Did you setup your channels manually, if so did you set them up correctly?
Author:  aten2005 [ Mon Mar 27, 2006 4:54 pm ]
Post subject: 
elgordo123 wrote:
It it's never been connected to the internet, then more than likely it has no channels setup. Did you setup your channels manually, if so did you set them up correctly?


im sorry, but i never knew that was possible.
where can i find this utility?
Author:  aten2005 [ Mon Mar 27, 2006 7:44 pm ]
Post subject: 
Xsecrets wrote:
tv does not require an internet connection (at least not after you have your channel data downloaded) and I've never seen it complain about not having an "internet" connection. I have seen cannot connect to master backend. there is a big difference. Is your box all on one machine or are you trying to run frontend/backend on different machines (in which case a network connection is required)?


Im acualy trying to run it all on one
Author:  mjl [ Mon Mar 27, 2006 9:23 pm ]
Post subject: 
Hi aten2005,

If you do an ( alt s ) that will open the setup menu. Then go through each item, select your tuner card, use tuner0, and add an entries for a source, I use Video and RF, then add a channel 1 for the video source and channel 3 for the rf source, be sure to set the freq id as 1 & 3 also. Later as you so choose, you could add your other local channels as desired however these settings should give you two connections to the outside world. You won't have any listings for the guide which is quite a nice feature. I haven't tried it however I believe you can do dialup for internet connection, so for only a few $ you can get your listings from labs.zap2it.com, even once a week is good.

Hope this is of assistance.
Mike
Page 1 of 1 All times are UTC - 6 hours
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/