| LinHES Forums http://forum.linhes.org/ |
|
| ATSC is 0% signal after rebooting from install R5F1 http://forum.linhes.org/viewtopic.php?f=15&t=15733 |
Page 1 of 1 |
| Author: | Das Hammer [ Fri Jun 29, 2007 4:59 am ] |
| Post subject: | ATSC is 0% signal after rebooting from install R5F1 |
Installed R5F1 using the AutoInstall. Running a combined frontend/backend setup here. The install went fine. When the backend setup first appeared, I was able to scan for ATSC channels and it found all 12 in my area. Then, once the frontend came up, I chose "Watch TV" and all the channels were there. Signal ranged from 100% to 30%. All channels watchable. I rebooted because I had to fix a line in the hardware.conf for my remote control. Upon rebooting, there was 0% signal on all channels. So, I did the obvious of checking the coax connections...all fine. TV is still playing upstairs which is being fed from the same antenna. So, I quit the frontend, stopped the backend and went to the backend setup. I did a full scan again on ATSC. Started the backend, started the frontend and "We get signal". Hooray...until a reboot. Then we're back to 0%. I don't understand what is causing this to happen. But, it is very reproducible on my machine. ANY input is appreciated. Hardware for what it's worth asus m2npv-vm board with nvidia 6150 built-in athlon x2 1.9GHz dual core Air2PC rev 0.2 Twinhan 1025 DVB-S ata hard drive ata optical drive |
|
| Author: | Das Hammer [ Fri Jun 29, 2007 6:31 am ] |
| Post subject: | |
"Entourage" has just pointed out to me that this is a known issue with the Rev0.2 Air2PC. Apparently there is a delay before it will start tuning after a boot. Thanks. |
|
| Author: | snaproll [ Mon Jul 09, 2007 11:33 am ] |
| Post subject: | |
Yes- Typical 'normal' behavior for a 0.2 Air2PC card. |
|
| Page 1 of 1 | All times are UTC - 6 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|