LinHES Forums
http://forum.linhes.org/

Dead lock during conf. of backend.
http://forum.linhes.org/viewtopic.php?f=17&t=10659
Page 1 of 1

Author:  Staach [ Thu Jun 29, 2006 12:03 am ]
Post subject:  Dead lock during conf. of backend.

During installation I got an error about / .qt (not installed). Later on during configuration of the backend in the third part (cannot remember the menu name but it´s just after setting XMLTV up) the pc starts doing a scan. It starts at 50% and then apparently ends up in a dead lock.

Does this problem has anything to do about the missing /.qt?
I found the following about installing QT (what is it anyway?) on http://www.mythtv.org/docs/mythtv-HOWTO-9.html
$ su -
# apt-get install libqt3c102-mt-mysql
# exit

If not, can any one lead me in the "right" direction on solving this dead lock during the scan?

Info: I use a PVR 350. The pc is connected to cable tv in Denmark.

Author:  cesman [ Thu Jun 29, 2006 4:39 pm ]
Post subject: 

You can ignore the /.qt error. As for the other, sounds like mythfilldatabase is choking on something. Run mythtv-setup from an xterm and <alt><tab> to see the output.

Author:  Staach [ Thu Jun 29, 2006 11:28 pm ]
Post subject: 

Ok..I will try this as soon as I get the time. I have an idea that XMLTV isn't configured..

Author:  Staach [ Mon Jul 03, 2006 12:29 am ]
Post subject: 

Ok..found out what the problem was. N00b problem actually..Hadn´t found any where that I was to open a terminal in which the xmltv was beeing configured..Some input was needed..

Page 1 of 1 All times are UTC - 6 hours
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/