LinHES Forums
http://forum.linhes.org/

Warnings while compiling MythTV .20
http://forum.linhes.org/viewtopic.php?f=17&t=11693
Page 1 of 1

Author:  dmcman73 [ Mon Sep 18, 2006 11:51 am ]
Post subject:  Warnings while compiling MythTV .20

Ok, I downloaded MythTV .20-fixes and I ran make (after of course running ./configure, qmake, etc) and I receive these errors all throughout the build process:

distcc[20179] (dcc_get_hostlist) Warning: no hostlist is set; can't distribute work
distcc[20179] (dcc_build_somewhere) Warning: failed to distribute, running locally instead

The version I am trying to install it on is Knoppmyth R5C7 and i had apt-get gcc version 3.3 prior to running make. I did not remove the DEB package of .19 that came with R5C7 yet as I wanted to make sure that I could build .20 without any errors.

Can I ignore these Warnings? It hasn't completed the make process yet so I am not sure if I will have errors or if the make process bombs yet.

Thanks.

*********EDIT************

Ok, it just finished and I did not see any errors reported just the Warnings as noted above. Can I ignore them or will it pose a problem?

Thanks again.

Author:  tjc [ Mon Sep 18, 2006 5:28 pm ]
Post subject: 

You can ignore those. The makefiles are set up to use distcc to have a group of machines on the same LAN share the load to speed up compiles, but lacking that it works OK on a single isolated machine.

Author:  dmcman73 [ Tue Sep 19, 2006 2:36 pm ]
Post subject: 

Thanks, I actually found a page describing this to. I installed .20 without a hitch.

Page 1 of 1 All times are UTC - 6 hours
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/