| LinHES Forums http://forum.linhes.org/ |
|
| non-serial IRblaster help needed http://forum.linhes.org/viewtopic.php?f=17&t=13166 |
Page 1 of 1 |
| Author: | schmeckendeugler [ Fri Dec 29, 2006 6:14 pm ] |
| Post subject: | non-serial IRblaster help needed |
Hello all, Click Here for a picture of the thing... I have this thing which I'm assuming is an IR blaster somebody gave me. Unfortunately, I am not sure how to set it up. I want to use it because I have digital cable and of course the digital cable signal must come after the box, and thus the channel-changing must be done via IR blaster. However, this thing is NOT a serial port; in fact it has a plug-in exactly like the plug-in for my Hauppauge PVR-350 IR Receiver. Otherwise during the Knoppmyth setup I would've said, "YES" at the point where it asked me if I had a serial port IR blaster. Can anybody point me in the right direction as to how to even install this thing? Do I plug it into the hole for IR on my PVR-350? If not, is the thing completely worthless? Can anybody offer some assistance here? Maybe point me to a better forum article/ knoppmythwiki page? |
|
| Author: | tjc [ Fri Dec 29, 2006 6:23 pm ] |
| Post subject: | |
It's most likley the IR dongle for a PVR-150, unfortunately the PVR-350 doesn't have the hardware to support it... |
|
| Author: | schmeckendeugler [ Fri Dec 29, 2006 6:24 pm ] |
| Post subject: | i wanna thank you for lettin' me be myself -Prince |
WOW FAST RESPONSE! OK, well, I guess I'll forget about it then. Thanks. |
|
| Author: | tjc [ Fri Dec 29, 2006 6:40 pm ] |
| Post subject: | |
Actually doesn't look like the PVR-150 one (picture), maybe it's from a TIVO or the like, but the answer still applies. |
|
| Page 1 of 1 | All times are UTC - 6 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|
