| LinHES Forums http://forum.linhes.org/ |
|
| Multiple Tuners, One Source http://forum.linhes.org/viewtopic.php?f=17&t=13198 |
Page 1 of 1 |
| Author: | DarkDevil [ Sun Dec 31, 2006 1:11 am ] |
| Post subject: | Multiple Tuners, One Source |
I'm trying to install a second card. I've got a WinTv-Go working fine, but I want to add a WinTV PVR-150. Problem is i'm not sure how to set it properly. I had both running with duplicate sources, zap and zap2, and both are running off the same Full Tier basic cable. Problem is, both are inputted through coaxial, but /Dev/video0/ is the only one showing up with Television Input. I can't have both cards running as /Dev/Video0/ can I? I had the second card as /dev/video1 with composite1 input, but all i got was snow. How am i suppose to get both cards to input through "Television" (coaxial) |
|
| Author: | tjc [ Sun Dec 31, 2006 1:09 pm ] |
| Post subject: | |
Back to the http://www.knoppmythwiki.org/index.php?page=BlackScreenWatchingTV troubleshooting page, where it says: Quote: If you have a PVR card (Hauppauge PVR-150, PVR-250, PVR-350, PVR-500 or equivalent) select "MPEG-2 Encoder", your first card will be /dev/video0, the next one /dev/video1, and so on. If the page reports an error scanning your card then see the section about unknown/unrecognized tuner type below.
: If you are connecting an antenna or raw cable (no box) via coax use the lowest numbered Tuner input for the card. If your bttv card is seen first (check the log files!) it will be /dev/video0, and the ivtv card will be /dev/video1, otherwise it'll be reversed. OBTW - If the feed is the same you only need one source. |
|
| Page 1 of 1 | All times are UTC - 6 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|