| LinHES Forums http://forum.linhes.org/ |
|
| Q: Capture card setup & Connect source to input http://forum.linhes.org/viewtopic.php?f=17&t=15207 |
Page 1 of 1 |
| Author: | 1phYO9AV [ Sat May 12, 2007 10:57 pm ] |
| Post subject: | Q: Capture card setup & Connect source to input |
Hardware: Hauppauge WinTV PVR 350 DishPro sattelite system Connection: Coax out (dish) > Coax in (pvr350) A/V out (pvr350 - composite V, L+R A) > Compsite in (TV) KnoppMyth configuration: Capture card setup Card type: Mpeg2 encoder card (PVR-x50, PVR-500) Video device: /dev/video0 Probed info: Hauppauge WinTV PVR 350 [ivtv] Default input: Tuner1 Connect Source to input Display name: Hauppauge Video source: dish External channel ...: <blank> Preset tuner ... : <blank> Starting channel: 105 Input priority: 0 Should these settings work for with my hardware and connection setup? After I reboot and try to Watch TV, I am only getting white noise, although the channel information does display. I hope this post is appropriate for this forum. I am not sure, if it would be considered a KnoppMyth installation or MythTV configuration question, but since it is part of the installation setup, I figured I'll give it a shot ... Any advice would be really appreciated. This is my first-time setup and this is my only glitch (thus far). Thanks! |
|
| Author: | tjc [ Sun May 13, 2007 8:59 am ] |
| Post subject: | Re: Q: Capture card setup & Connect source to input |
1phYO9AV wrote: Connection: Coax out (dish) > Coax in (pvr350) A/V out (pvr350 - composite V, L+R A) > Compsite in (TV) You would be better off using an S-Video comnnection from the box to the capture card if it's available. It'll give you better picture quality. 1phYO9AV wrote: KnoppMyth configuration:
: Connect Source to input Display name: Hauppauge Video source: dish External channel ...: <blank> Preset tuner ... : <blank> Starting channel: 105 Input priority: 0 If you're using an external box, you need an external channel changer script. If you're connecting it via co-ax to the tuner input on your card you need to set the pretune channel to the one that the box is rebroadcasting on. See the troubleshooting pages on the wiki: http://www.knoppmythwiki.org/index.php?page=TroubleShooting Especially: http://www.knoppmythwiki.org/index.php?page=BlackScreenWatchingTV Read them carefully and pay attention to the details. |
|
| Author: | 1phYO9AV [ Tue May 15, 2007 10:00 am ] |
| Post subject: | |
tjc - I am using the SVHS connection now and I am getting my picture. I've modified the default external channel changer script and entered the name of my remote from lircd.conf in it and entered the scipt name into the KnoppMyth config field. No dice - but that's OK. Everything else works. I'll figure it out eventually. Thanks for your help! |
|
| Page 1 of 1 | All times are UTC - 6 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|