| LinHES Forums http://forum.linhes.org/ |
|
| Dual PVR-250's - Only one and half working http://forum.linhes.org/viewtopic.php?f=17&t=16165 |
Page 1 of 1 |
| Author: | bwente [ Fri Aug 17, 2007 5:54 pm ] |
| Post subject: | Dual PVR-250's - Only one and half working |
I recently upgraded and I have lost more than half the channels on my second card. Channels below 62 are snow and garbage. I think I upgraded the firmware. It has been two weeks I still can't get it to work. Any suggestions? In my /etc/mythtv/modules/ivtv I have this... Code: alias char-major-81 videodev alias char-major-61 lirc_i2c alias char-major-81-0 ivtv alias char-major-81-1 ivtv # options ivtv ivtv_std=0 tuner=39 # options ivtv tuner=39 options ivtv tuner=50,50 install ivtv /sbin/modprobe tuner; /sbin/modprobe msp3400; /sbin/modprobe saa7115; /sbin/modprobe --ignore-install ivtv remove ivtv /sbin/modprobe -r --ignore-remove ivtv && /sbin/modprobe -r saa7115 && /sbin/modprobe -r msp3400 && /sbin/modprobe -r tuner dmesg | grep ivtv Code: ivtv: ==================== START INIT IVTV ====================
ivtv: version 0.10.5 (tagged release) loading ivtv: Linux version: 2.6.18-chw-13 SMP preempt mod_unload 586 gcc-4.1 ivtv: In case of problems please include the debug info between ivtv: the START INIT IVTV and END INIT IVTV lines, along with ivtv: any module options, when mailing the ivtv-users mailinglist. ivtv0: Autodetected Hauppauge card (cx23416 based) ivtv0: Unreasonably low latency timer, setting to 64 (was 32) ivtv0: loaded v4l-cx2341x-enc.fw firmware (376836 bytes) ivtv0: Encoder revision: 0x02060039 tuner 1-0061: chip found @ 0xc2 (ivtv i2c driver #0) msp3400 1-0040: MSP3445G-B8 found @ 0x80 (ivtv i2c driver #0) saa7115 1-0021: saa7115 found (1f7115d0e100000) @ 0x42 (ivtv i2c driver #0) ivtv0: Autodetected Hauppauge WinTV PVR-250 ivtv0: Registered device video0 for encoder MPEG (4 MB) ivtv0: Registered device video32 for encoder YUV (2 MB) ivtv0: Registered device vbi0 for encoder VBI (1 MB) ivtv0: Registered device video24 for encoder PCM audio (1 MB) ivtv0: Initialized Hauppauge WinTV PVR-250, card #0 ivtv: ====================== NEXT CARD ====================== ivtv1: Autodetected Hauppauge card (cx23415 based) ivtv1: Unreasonably low latency timer, setting to 64 (was 32) ivtv1: loaded v4l-cx2341x-enc.fw firmware (376836 bytes) ivtv1: loaded v4l-cx2341x-dec.fw firmware (262144 bytes) ivtv1: Encoder revision: 0x02060039 ivtv1: Decoder revision: 0x02020023 tuner 2-0061: chip found @ 0xc2 (ivtv i2c driver #1) msp3400 2-0040: MSP4448G-A2 found @ 0x80 (ivtv i2c driver #1) saa7115 2-0021: saa7115 found (1f7115d0e100000) @ 0x42 (ivtv i2c driver #1) ivtv1: Autodetected Hauppauge WinTV PVR-250 ivtv1: Registered device video2 for encoder MPEG (4 MB) ivtv1: Registered device video33 for encoder YUV (2 MB) ivtv1: Registered device vbi1 for encoder VBI (1 MB) ivtv1: Registered device video25 for encoder PCM audio (1 MB) ivtv1: Initialized Hauppauge WinTV PVR-250, card #1 ivtv: ==================== END INIT IVTV ==================== ir-kbd-i2c: i2c IR (Hauppauge) detected at i2c-1/1-0018/ir0 [ivtv i2c driver #0] |
|
| Author: | bwente [ Fri Aug 31, 2007 4:37 pm ] |
| Post subject: | |
Going on four weeks now, any help? Did I post this in the wrong place? I usually do not ask for help, but this one has me stumped. |
|
| Author: | cecil [ Fri Aug 31, 2007 4:51 pm ] |
| Post subject: | |
I don't see anything obvious from what you posted. Did you try the ivtv or mythtv mailing list? |
|
| Author: | bruce_s01 [ Fri Aug 31, 2007 5:18 pm ] |
| Post subject: | |
Have you shutdown your machine completely by disconnecting it from the mains, so after powring it up again to ensure it reloads the firmware? Is there an external splitter to connect up the two inputs? Have you checked that this is OK with the associated wiring? Have you swapped the two connections around to show whether it's the card or the inputs? Did you do anything systemwise just before you lost the signals on that card? Bruce S. |
|
| Author: | bwente [ Mon Sep 01, 2008 9:19 am ] |
| Post subject: | |
I finally got this working by editing /etc/mythtv/modules/ivtv to autodetect both cards. options ivtv tuner=-1,-1 I had 38,50 before. |
|
| Page 1 of 1 | All times are UTC - 6 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|