| LinHES Forums http://forum.linhes.org/ |
|
| xmltv guide data off http://forum.linhes.org/viewtopic.php?f=17&t=16492 |
Page 1 of 1 |
| Author: | rkshack [ Thu Sep 13, 2007 3:21 pm ] |
| Post subject: | xmltv guide data off |
I am using an xmltv grabber to make guide data. The programs are loading correctly just 5 hours off. This is the same amount of time I am off of utc. I have gone into timezone config and I am set up as central time which is correct. Bios is set to utc. My xmltv file has the time -0000. No offset. Should there be? rkshack |
|
| Author: | mihanson [ Thu Sep 13, 2007 3:29 pm ] |
| Post subject: | |
Yes. Try -0500. |
|
| Author: | rkshack [ Thu Sep 13, 2007 4:49 pm ] |
| Post subject: | |
If I can't get the xmltv generator to put an offset in, is there a way to fix this issue. |
|
| Author: | mihanson [ Thu Sep 13, 2007 4:52 pm ] |
| Post subject: | |
You should be able to do this in mythtv-setup. Alt-2 Alt-S General, I believe. If it's not there it's in Utilities/Setup General. I'm not in front of my box ATM. |
|
| Author: | tjc [ Thu Sep 13, 2007 7:30 pm ] |
| Post subject: | |
You might want to try the procedure here. http://www.knoppmythwiki.org/index.php?page=ProgramGuideIsOff |
|
| Author: | rkshack [ Thu Sep 13, 2007 7:41 pm ] |
| Post subject: | |
mihanson wrote: You should be able to do this in mythtv-setup. Alt-2 Alt-S General, I believe. If it's not there it's in Utilities/Setup General. I'm not in front of my box ATM.
Thanks. I had to change xmltv time offset to auto. It was set to none and so interpreted all times off the xmltv file as auto. rkshack |
|
| Author: | rkshack [ Thu Sep 13, 2007 7:44 pm ] |
| Post subject: | |
tjc wrote: You might want to try the procedure here. http://www.knoppmythwiki.org/index.php?page=ProgramGuideIsOff
Thanks for the suggestion. I had done that and had my system time and time zone and everything set correctly. I just had to change the setting in mythtv setup. I changed the xmltv time offset to auto in the general page and everything is good. It was on none. Thanks rkshack |
|
| Author: | tjc [ Thu Sep 13, 2007 7:48 pm ] |
| Post subject: | |
Could I trouble you to update that wiki page and add the bit about making sure it's set to auto? Thanks! |
|
| Author: | rkshack [ Thu Sep 13, 2007 8:19 pm ] |
| Post subject: | |
No problem |
|
| Page 1 of 1 | All times are UTC - 6 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|