I have two boxes - a master and slave backend setup. In mythtv-setup on each I have the "run jobs only on original recording backend" checked. I also have "allow commercial detection jobs" checked on each.

The slave backend works as expected; it flags commercials as soon as the recording stops. The master backend queues the commercial flagging jobs, but they do not run. I can run mythcommflag by hand on the master and everything is fine. There is no relevant information in mythbackend.log

Does anyone know where I might look to get mythcommflag running automatically?

Thanks,
Hari

I finally figured this out. I ran "mythjobqueue -v all" and it told me that the time was outside of the job queue window. I checked mythtv-setup and found that the job start and end times were both set to 00:00. I changed the job end time to 23:59 and now all is working again.