View unanswered posts    View active topics

Board index KnoppMyth Hardware

All times are UTC - 6 hours





Post new topic Reply to topic  Page 3 of 3
  [ 36 posts ] 
Go to page Previous  1, 2, 3
Print view Previous topic   Next topic  
Author Message
Search for:
brendan
 Post subject:
PostPosted: Fri Jun 17, 2005 7:57 am 
Offline
Joined: Tue Dec 07, 2004 12:04 pm
Posts: 369
Atamido wrote:
Okay, I got ivtv-0.3.6n downloaded and installed (I'm pretty sure) but it still shows static. In the message logs it still has
Code:
tveeprom: Hauppauge: model = 26032, rev = C199, serial# = 2936154
tveeprom: tuner = <unknown> (idx = 99, type = 0)
tveeprom: tuner fmt = NTSC(M) (eeprom = 0x08, v4l2 = 0x00001000)
tveeprom: audio_processor = TDA9850 (type = 3)

...


Having caused a problem and reverted, I now feel like I'm getting somewhere. I couldn't find a v4l directory to check for duplicate ivtv modules, but the log/messages seems to show the right one being loaded.



The tuner = <unknown> is pretty good evidence that you're using the v4l tuner module and not the ivtv one, which means you might be mixing and matching other modules as well.

I think the dir is:

/lib/modules/2.6.11.7-chw-4/v4l2

The ivtv make install put newer ones in here:

/lib/modules/2.6.11.7-chw-4/ivtv

...but it's likely the ones in v4l2 are being seen first.

-brendan
Top
 Profile  
 
Atamido
 Post subject:
PostPosted: Fri Jun 17, 2005 11:09 am 
Offline
Joined: Wed Jun 15, 2005 9:14 pm
Posts: 72
Okay, here is my v4l2 directory listing.
Code:
bt878.ko           cx88-dvb.ko   dvb-core.ko     or51132.ko          tda1004x.ko     v4l2-common.ko
btcx-risc.ko       cx8800.ko     dvb-pll.ko      or51211.ko          tda9887.ko      video-buf-dvb.ko
bttv.ko            cx8801.ko     ir-common.ko    saa6752hs.ko        tuner.ko        video-buf.ko
cx22702.ko         cx8802.ko     ir-kbd-gpio.ko  saa7134-dvb.ko      tvaudio.ko
cx24110.ko         cx88xx.ko     ir-kbd-i2c.ko   saa7134-empress.ko  tveeprom.ko
cx88-atsc.ko       dst.ko        mt352.ko        saa7134.ko          tvmixer.ko
cx88-blackbird.ko  dvb-bt8xx.ko  nxt6000.ko      sp887x.ko           v4l1-compat.ko

Here is my ivtv directory listing.
Code:
cx25840.ko  ivtv.ko     saa7115.ko  tda9887.ko  tveeprom.ko
ivtv-fb.ko  msp3400.ko  saa7127.ko  tuner.ko    wm8775.ko

What files should I be deleting/copying from where?
Top
 Profile  
 
Atamido
 Post subject:
PostPosted: Fri Jun 17, 2005 11:29 am 
Offline
Joined: Wed Jun 15, 2005 9:14 pm
Posts: 72
I renamed tda9887.ko tuner.ko and tveeprom.ko in the v4l2 directory then commented out the line that I added in the ivtv file. Now I'm back to static on all of the channels. :?

However, the log shows good stuff from tveeprom.
Code:
tveeprom: Hauppauge: model = 26032, rev = C199, serial# = 2936154
tveeprom: tuner = TCL 2002N 5H (idx = 99, type = 50)
tveeprom: tuner fmt = NTSC(M) (eeprom = 0x08, v4l2 = 0x00001000)
tveeprom: audio_processor = TDA9850 (type = 3)

So now it autodetects a tuner and a type. I just wish I knew what to do with this useful piece of information.
Top
 Profile  
 
Atamido
 Post subject:
PostPosted: Sat Jun 18, 2005 9:30 am 
Offline
Joined: Wed Jun 15, 2005 9:14 pm
Posts: 72
Having removed the old .ko files, I still can't even get it to work with the old line I had in my ivtv file uncommented. I was looking at the startup log and noticed "cx25840: requesting /lib/modules/HcwMakoA.ROM", but that file wasn't there so I downloaded it from the Hauppage site and put it there. It didn't make a difference. But I thought I would post the whole log here in case anyone else could notice something horribly wrong.

Code:
ivtv: ==================== START INIT IVTV ====================
ivtv: version 0.3.6 (o) loading
ivtv: Linux version: 2.6.11.9-chw-2 SMP preempt 586 gcc-3.3
ivtv: In case of problems please include the debug info
ivtv: between the START INIT IVTV and END INIT IVTV lines when
ivtv: mailing the ivtv-devel mailinglist.
ivtv: Autodetected WinTV PVR 150 card
ivtv: Found an iTVC16 based chip
ACPI: PCI Interrupt Link [LNK4] enabled at IRQ 10
ACPI: PCI interrupt 0000:01:07.0[A] -> GSI 10 (level, low) -> IRQ 10
ivtv: Unreasonably low latency timer, setting to 64 (was 32)
ivtv: XXX PCI device: 0x01e0 vendor: 0x10de
tuner: chip found at addr 0xc2 i2c-bus ivtv i2c driver #0
ivtv: i2c attach [client=(tuner unset),ok]
saa7115: starting probe for adapter ivtv i2c driver #0 (0x10005)
tveeprom: Hauppauge: model = 26032, rev = C199, serial# = 2936154
tveeprom: tuner = TCL 2002N 5H (idx = 99, type = 50)
tveeprom: tuner fmt = NTSC(M) (eeprom = 0x08, v4l2 = 0x00001000)
tveeprom: audio_processor = TDA9850 (type = 3)
ivtv: i2c attach [client=tveeprom[50],ok]
iivtv: Tuner Type 50, Tuner formats 0x00001000, Radio: yes, Model 0x008d1659, Revision 0x00000000
ivtv: NTSC tuner detected
ivtv: Radio detected
cx25840: requesting /lib/modules/HcwMakoA.ROM
cx25840: firmware loaded
ivtv: i2c attach [client=cx25840[50],ok]
ivtv: i2c attach [client=wm8775[50],ok]
ivtv: Encoder revision: 0x02040011
ivtv: Configuring WinTV PVR 150 card with 5 streams
ivtv: Registered v4l2 device, streamtype 0 minor 0
ivtv: Create DMA stream 0 using 128 32768 byte buffers  0 kbytes total
ivtv: Registered v4l2 device, streamtype 1 minor 32
ivtv: Create DMA stream 1 using 194 10800 byte buffers  0 kbytes total
ivtv: Registered v4l2 device, streamtype 2 minor 224
ivtv: Create DMA stream 2 using 240 8736 byte buffers  0 kbytes total
ivtv: Registered v4l2 device, streamtype 3 minor 24
ivtv: Create DMA stream 3 using 455 4608 byte buffers  0 kbytes total
ivtv: Registered v4l2 device, streamtype 4 minor 64
ivtv: Create stream 4
ivtv: Setting Tuner 50
tuner: type set to 50 (TCL 2002N) by ivtv i2c driver #0
ivtv: ivtv_enc_thread: pid = 3145, itv = 0xe11e4820
ivtv: ivtv_enc_vbi_thread: pid = 3146, itv = 0xe11e4820
ivtv: Switching standard to NTSC.
ivtv: Initialized WinTV PVR 150, card #0
ivtv: ====================  END INIT IVTV  ====================
Top
 Profile  
 
Atamido
 Post subject:
PostPosted: Sat Jun 18, 2005 10:11 am 
Offline
Joined: Wed Jun 15, 2005 9:14 pm
Posts: 72
Contents of my /etc/mythtv/modules/ivtv file
Code:
alias char-major-81 videodev
alias char-major-61 lirc_i2c
#options ivtv ivtv_std=1 tuner=47 tda9887=0 ivtv_debug=0
#options ivtv debug=1
#options tuner type=2
options msp3400 once=1 simple=1
install ivtv /sbin/modprobe tuner; /sbin/modprobe msp3400; /sbin/modprobe saa7115;  /sbin/modprobe --ignore-install  ivtv
remove ivtv /sbin/modprobe -r --ignore-remove ivtv && /sbin/modprobe -r saa7115 && /sbin/modprobe -r msp3400 && /sbin/modprobe -r tuner
Top
 Profile  
 
Atamido
 Post subject:
PostPosted: Mon Jun 20, 2005 12:17 pm 
Offline
Joined: Wed Jun 15, 2005 9:14 pm
Posts: 72
Problem fixed. I had the wrong coax cable hooked up. :roll:

Contents of my /etc/mythtv/modules/ivtv file now
Code:
alias char-major-81 videodev
alias char-major-81-0 ivtv
Top
 Profile  
 

Display posts from previous:  Sort by  
Post new topic Reply to topic  Page 3 of 3
  [ 36 posts ] 
Go to page Previous  1, 2, 3


Board index KnoppMyth Hardware

All times are UTC - 6 hours




Who is online

Users browsing this forum: Bing [Bot] and 30 guests

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Jump to:  
cron
Powered by phpBB® Forum Software © phpBB Group

Theme Created By ceyhansuyu