I have a PVR-150 card and a A180 card in my system. I got the A180 card working following some instructions I found on the forum. The PVR-150 however does not seem to change channels. Since I am a newbie to Linux does anyone have detail steps to fix this problem?

Thanks
Trampas

Get back into mythtv-setup (directions from the wiki - http://www.knoppmythwiki.org/index.php?page=GettingBackIntoMytTVsetup) and under input connections make sure you _only_ associated the tuner with the listing source. While you're there make sure that you defined the card properly.

Thanks for the reply, from what others have said the Win PVR-150 has a couple of different tuner modules. Thus the KnoppMyth install may have installed the incorrect one and that is my problem. I now need to figure out how verify this and fix it.

Trampas

See the CheckingLogFiles and CompileIvtv pages on the wiki.

- In the logfiles you're looking to see if the tuner was recognized.

- If it wasn't and you're using R5C7 you'll need to go to 0.4.6 following the CompileIvtv page (substitute 4.4 -> 4.6)

BTW - searching for those terms here will turn up links to the wiki.