| LinHES Forums http://forum.linhes.org/ |
|
| Homemade serial port IR-reciver + Hauppauge Remote A415-HPG? http://forum.linhes.org/viewtopic.php?f=2&t=11010 |
Page 1 of 1 |
| Author: | gfg [ Sun Jul 30, 2006 8:00 am ] |
| Post subject: | Homemade serial port IR-reciver + Hauppauge Remote A415-HPG? |
I have a PVR-150 with a broken IR-reciver, so I'm using a serial port reciver instead. But how to get it to work with the A415-HPG remote? I tried the mode2 command and get a lot of numbers when using the remote, so it works, but the IRW command does nothing. At the install I choose hauppauge (16) and A415-HPG (c). |
|
| Author: | nickread [ Sun Jul 30, 2006 4:32 pm ] |
| Post subject: | |
Try creating/recording a new lircd.conf using irrecord |
|
| Author: | tjc [ Sun Jul 30, 2006 6:35 pm ] |
| Post subject: | |
I think you need to do a hybrid thing with the serial driver to talk to the device and the Hauppauge codes in /etc/lirc/lircd.conf. If you picked type 16 you're still trying to talk to the PVR card (via the ivtv driver?) when you need to be using the lirc_serial driver. |
|
| Author: | gfg [ Sun Jul 30, 2006 9:49 pm ] |
| Post subject: | |
And how do I pick the lirc_serial driver? |
|
| Author: | Bonobo1 [ Mon Oct 02, 2006 3:20 pm ] |
| Post subject: | |
Mode2 worked fine, but when I came to the point to use irw, it failed. In the /etc/lircd.conf file I changed the following lines "flags RC5" to "flags RC5|CONST_LENGTH" "one 0 0" to "one 936 832" "zero 0 0" to "zero 936 832" added the line "plead 970" and changed "gap 0" to "gap 113754" After these changes irw worked properly. |
|
| Page 1 of 1 | All times are UTC - 6 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|