| LinHES Forums http://forum.linhes.org/ |
|
| R5D1 D-Link ath0 problems http://forum.linhes.org/viewtopic.php?f=2&t=11378 |
Page 1 of 1 |
| Author: | jac1d [ Wed Aug 30, 2006 8:01 am ] |
| Post subject: | R5D1 D-Link ath0 problems |
Since installing R5D1 I can't seem to get my wireless DLink to confugure. It worked under previous releases. When I run iwconfig it says: Warning: Driver for device ath0 has been compiled with version 20 of Wireless Extension, while this program supports up to version 17. Some things may be broken... ath0 IEEE 802.11g ESSID:"DianaGrace" Mode:Managed Frequency:2.457 GHz Access Point: 00:00:00:00:00:00 Bit Rate=54 Mb/s Tx-Power:18 dBm Sensitivity=0/3 Retry:off RTS thr:off Fragment thr:off Encryption key:XXXX-XXXX-XXX-XXX-0BDA-A4DB-6A Security mode:restricted Power Management:off Link Quality=0/94 Signal level=-95 dBm Noise level=-95 dBm Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0 Tx excessive retries:0 Invalid misc:0 Missed beacon:0 sit0 no wireless extensions. root@mythtv:~# And when I configure it (with or without WEP, as I dropped WEP to see if I could get it to work in the clear) it doesn't see the AP or associate. Has anyone else seen this or gotten their DLINK card to work on R5D1? Thanks! -Jeff |
|
| Author: | jac1d [ Wed Aug 30, 2006 12:12 pm ] |
| Post subject: | |
Stupid mistake on my part. The AP in my in-laws house is 802.11b 11Mbps only, and I copied over my config from home with runs at 802.11g. THe problem was me forcing the 54 Mbps. I turned the speed to auto and all is well. Back to installing R5D1. Sorry for the false report. -Jeff |
|
| Page 1 of 1 | All times are UTC - 6 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|