| LinHES Forums http://forum.linhes.org/ |
|
| Changed nic how do I enable at startup SOLVED! http://forum.linhes.org/viewtopic.php?f=2&t=13637 |
Page 1 of 1 |
| Author: | alexvd [ Fri Jan 19, 2007 4:51 pm ] |
| Post subject: | Changed nic how do I enable at startup SOLVED! |
Hi i have a motherboard with a integrated marvell gigabit nic installed. Pre RD51 is was not working so I installed a intel 10/100 pci nic. When I upgraded to RE50 I tested the embedded nic and was happy to findout it worked. So I removed the pci nic. Now I don't have network connectivity until I configure the gigabit nic via netcardconfig or manually. How do I configure knoppmyth to load the embedded nic on startup? |
|
| Author: | tjc [ Fri Jan 19, 2007 7:54 pm ] |
| Post subject: | |
Run netcardconfig. |
|
| Author: | alexvd [ Fri Jan 19, 2007 8:26 pm ] |
| Post subject: | |
Hi TjC as I posted I ran netcardconfig. It works with no issues unless I reboot. Then i have to repeat the process. is thier a way to make this permanent. |
|
| Author: | tjc [ Fri Jan 19, 2007 8:43 pm ] |
| Post subject: | |
Sorry, missed that when I read your note. Unless it's got a module load order problem it _should_ just work. Is the card identified as /dev/eth0 or /dev/eth1? What does ifconfig show? What module does the builtin NIC need? Did you set up for DHCP or static IP? What does cat /etc/sysconfig/network-scripts/ifcfg-eth? show? |
|
| Author: | alexvd [ Wed Jan 24, 2007 4:59 pm ] |
| Post subject: | solved issue |
TJC, I had to an autoupgrade of the box to move to RE50. After manually configuring static settings it seems to work. I rebooted and it kept the static address for the integrated NIC. I think I originally screwed it up myself because when I removed the add-on nic I went into the interfaces section and edited some settings. I think i removed the etho entries. It does not matter anymore as it is working. Thanks for helping. |
|
| Page 1 of 1 | All times are UTC - 6 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|