LinHES Forums
http://forum.linhes.org/

setserial on startup
http://forum.linhes.org/viewtopic.php?f=2&t=14074		 Page 1 of 1
Author:  stormb [ Wed Feb 07, 2007 1:27 pm ]
Post subject:  setserial on startup
Hi, this sounds a really obvious question but I've been trying to find the answer for a while and not got anywhere.

I want to run Lircd on startup, but it won't run until I 'setserial /dev/ttyS0 uart none', and I can't work out how to do it automatically before lircd launches in the rc.d scripts.

It works if I do it once the system has booted up, then I run lircd manually.

I'm running R5D1 at the moment (bit too scared to update in case everything messes up :)), and the lirc receiver is a very basic serial one.

Anyone?

Thanks in advance,

Will
Author:  stormb [ Wed Feb 07, 2007 1:43 pm ]
Post subject: 
Ah, it's OK. I think the answer may be that I need to add the command to bootmisc.sh. I'll try that and return back :)

Will
Author:  stormb [ Sat Feb 10, 2007 7:13 pm ]
Post subject: 
OK, sorted. Had to make sure /etc/lirc/hardware.conf had lirc_serial listed as one of the modules to load.

Also made sure the right serial port settings were in /var/lib/setserial/autoserial.conf.
Page 1 of 1 All times are UTC - 6 hours
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/