| LinHES Forums http://forum.linhes.org/ |
|
| pvr-350 msp3400 not detected!! http://forum.linhes.org/viewtopic.php?f=2&t=14271 |
Page 1 of 1 |
| Author: | bzImage [ Sun Feb 18, 2007 4:36 pm ] |
| Post subject: | pvr-350 msp3400 not detected!! |
My mythtv system was working fine but yesterday i noticed no audio on my recordings. Rebooting the system i found that the ivtv driver reports: msp3400 not detected this card was working fine for 6 months. i reinstalled knoppmyth and even change to a new machine but i get the same error.. any hints ?? 
|
|
| Author: | bzImage [ Sun Feb 18, 2007 9:36 pm ] |
| Post subject: | |
The exact message is: ivtv0: i2c hardware 0x00000008 (msp3400) not found for command The pvr-350 was working fine and one day it stopped recording audio and showing that message. help please !! |
|
| Author: | bruce_s01 [ Mon Feb 19, 2007 1:22 pm ] |
| Post subject: | |
From your information, it sounds like your card has died. If installing it on another machine along with a reinstall of KM fails, that usually point to a common point of failure, namely the card. The only thing I suggest is removing the card from the machine and have a good look at the card to check if any obvious failures have happend (Heat sink sliding off, any obvious shorts, components browned/blackened) Bruce S. |
|
| Author: | bzImage [ Mon Feb 19, 2007 4:16 pm ] |
| Post subject: | |
i took out the card and look for burnt chips or something unusual but found nothing. Then i press down the big black heat disipator on the card (on the center of the card, is a big black square), i pressed hard and to the sides, just in case something was not properly seated under it. i reinserted the pvr-350 card and now i dont get the error about the missing msp3400 
will check if everything is working ok tomorrow. |
|
| Page 1 of 1 | All times are UTC - 6 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|