| LinHES Forums http://forum.linhes.org/ |
|
| streamzap ir http://forum.linhes.org/viewtopic.php?f=2&t=20540 |
Page 1 of 1 |
| Author: | abigailsweetashoney [ Thu Nov 19, 2009 1:20 pm ] |
| Post subject: | streamzap ir |
I've noticed that my streamzap remote's commands does not work very well if the streamzap receiver isn't pointed directly at me. When on a slight angle the receiver blinks (i.e. it *is* receiving the signal) but the command is ignored 30% to 60% of the time. Has anyone else seen this behavior? Thanks, -Abs |
|
| Author: | mihanson [ Thu Nov 19, 2009 2:52 pm ] |
| Post subject: | Re: streamzap ir |
abigailsweetashoney wrote: I've noticed that my streamzap remote's commands does not work very well if the streamzap receiver isn't pointed directly at me. When on a slight angle the receiver blinks (i.e. it *is* receiving the signal) but the command is ignored 30% to 60% of the time.
Has anyone else seen this behavior? FWIW, yes, I've seen this too. It is annoying, but I've learned to live with it. I just adjust my arm position and try again. 
|
|
| Author: | mattbatt [ Thu Nov 19, 2009 11:56 pm ] |
| Post subject: | |
You could try disasembling the reciever so that the plastic isn't covering the reciever. |
|
| Author: | novellahub [ Fri Nov 20, 2009 7:30 am ] |
| Post subject: | |
I have found out that the receiver works better when you have it pointed down towards the ground. I had to do that with my HDTV setup since the can lights in my ceiling were interfering. I have a second Streamzap remote for another slave machine and I tried the same thing. It definitely works better now and I can usedifferent angles around the room. |
|
| Author: | abigailsweetashoney [ Fri Nov 20, 2009 10:14 am ] |
| Post subject: | |
thanks, will try |
|
| Page 1 of 1 | All times are UTC - 6 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|