| LinHES Forums http://forum.linhes.org/ |
|
| getting pvr-350 to work after fresh install withR5 10a http://forum.linhes.org/viewtopic.php?f=2&t=3584 |
Page 1 of 1 |
| Author: | rkremser [ Sat Feb 19, 2005 3:41 am ] |
| Post subject: | getting pvr-350 to work after fresh install withR5 10a |
I had a working system earlier with R4v5 but after upgrading i can't get my pvr350 to be reconized using myth-setup. I am getting an error Failed to open /dev/video0 repeated 4 times I don't know what this could be I did not change any hardware so i'm not sure what caused this. I used tuner 39 before and set it again but again no luck. What am i missing? |
|
| Author: | cesman [ Sat Feb 19, 2005 1:49 pm ] |
| Post subject: | |
Did you modprobe ivtv? |
|
| Author: | rkremser [ Sat Feb 19, 2005 8:57 pm ] |
| Post subject: | |
i did that again and now the tuner is working but i am getting some strange messages when trying to enable the prv-350's tv out. I'm following http://ivtv.writeme.ch/tiki-index.php?page=TvOutHowto and at one point it says to Now just a quick test. Hook up your TV set to the composite out RCA jack of your PVR-350 and do this: * rmmod saa7127 * insmod saa7127 enable_output=1 output_select=0 test_image=1 upon trying the second insmod line i get an error insmod saa7127 enable_output=1 output_select=0 test_image=1 insmod: can't read 'saa7127': No such file or directory Any ideas as to what could be causing this? Also i can't run modprobe ivtv-fb without getting an error saying that there was a segmentation fault. My framebuffer goes unknown as it seemingly can't be opend (error when x tries to start and fails) |
|
| Author: | Greg Frost [ Sun Feb 20, 2005 1:21 am ] |
| Post subject: | |
The brute force way to solve this problem would be to locate module that you are trying to install and specify the full path to it. find / -name "saa7127*" Might come up with something like: /lib/modules/2.6.9/somdir/saa7127.ko Then run insmod /lib/modules/2.6.9/somdir/saa7127.ko enable_output=1 output_select=0 test_image=1 |
|
| Page 1 of 1 | All times are UTC - 6 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|