Thanks! No, that sounds right. Start MythTV from an xterm, if it doesn't connect to LIRC you'll see an error.
| LinHES Forums http://forum.linhes.org/ |
|
| Packard Bell Remote / Mythfrontend or Mythbackend http://forum.linhes.org/viewtopic.php?f=2&t=3808 |
Page 1 of 1 |
| Author: | snake3061 [ Sat Mar 05, 2005 6:04 pm ] |
| Post subject: | Packard Bell Remote / Mythfrontend or Mythbackend |
Great Job on the KNoppmyth guys.it works GREAT! Ok my question? I have KM up and running on a backend/frontend solution with 1 pvr-250 and 1 m179. The remote on this machine is working great! I am using the remote for the PVR-250. I also have a Frontend only machine with no PVR cards but I do have a Seriial IR and Remote. This is a Packard bell remote. one of those cheapies you can get for 9.00 on ebay. On this frontend machine once I set up the Serial device in the bootmisc.sh file /etc/init.d/bootmisc.sh added this : # Setup LIRC for Serial setserial /dev/ttyS0 uart none modprobe lirc_serial /usr/local/sbin/lircd /usr/local/sbin/lircmd I copied the packard bell config into the /etc/lircd.conf I copied the Pakard bell config I picked up for the remote into /home/mythtv/.mythtv/lircrc I can run irw and I see the codes. But nothing in mythtv is seeing it and I am not even sure it reads the lircrc file. I am doing something wrong? Thanks!!!! |
|
| Author: | cesman [ Sat Mar 05, 2005 6:37 pm ] |
| Post subject: | |
| Thanks! No, that sounds right. Start MythTV from an xterm, if it doesn't connect to LIRC you'll see an error.
|
|
| Page 1 of 1 | All times are UTC - 6 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|