| LinHES Forums http://forum.linhes.org/ |
|
| R5A16: Nexus-s DVB-s card not recognized http://forum.linhes.org/viewtopic.php?f=2&t=5623 |
Page 1 of 1 |
| Author: | chuckg [ Mon Aug 08, 2005 11:49 pm ] |
| Post subject: | R5A16: Nexus-s DVB-s card not recognized |
Hi: I've been trying to get my card to work for the last several days without much luck (been scouring the forums) - Auto Install of R5A16 (2.6 kernel) on an Athlon box with a Hauppauge Nexus-s (v2.3) DVB-s card - Installation went fine, except that the DVB-s card is NOT fully recognized - First problem I noticed was that during reboot, there is a message (in red) that says "Knoppmyth found no Multimedia Video Cards" - On lspci -v, here is the message that seems to indicate a problem --------- 0000:00:0a.0 Multimedia controller: Philips Semiconductors SAA 7146 (rev 01) Subsystem: Technotrend Systemtechnik Gmbh: Unknown device 000e Flags: bus master, medium devsel, latency 32, IRQ 5 Memory at ee010000 (32-bit, non-prefetchable) [size=512] --------- - Thought it may be a driver issue. So, I updated the firmware with dvb-ttpci-01.fw-261f - I made sure that the following modules were inserted and included in /etc/modules: dvb-core, dvb-ttpci, saa7146, saa7146_vv, ttpci-eeprom, skystar2, videodev, evdev, video-buf, stv0299... - Did NOT recompile kernel with linuxtv-dvb-1.1.1, because I assumed all the necessary drivers are already part of the 2.6 kernel (according to the README) - Rebooted, but problem still not resolved - Removed dvb-s card, rebooted, added back card, rebooted, but problem still not resolved I'm at a loss. I would greatly appreciate any pointers. Thank you! cg |
|
| Author: | chuckg [ Wed Aug 10, 2005 11:30 pm ] |
| Post subject: | |
Anyone?? Help please....I'm dying to get Myth running. |
|
| Author: | azzid_rob [ Mon Apr 17, 2006 6:22 am ] |
| Post subject: | |
I have the same problem. but theres an error called: Could not load firmware. Can nobody help? I tried everything. |
|
| Author: | joe [ Tue Apr 18, 2006 2:56 am ] |
| Post subject: | |
Same to me. But I have the DVB-C version. I get the driver loaded with a modprobe -r dvb-ttpci and after this with a modprobe dvb-ttpci. But the station scan is not working then. Can you report how you use the scan? Cheers Jo |
|
| Page 1 of 1 | All times are UTC - 6 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|