| LinHES Forums http://forum.linhes.org/ |
|
| PVR-350 Sound works but not with remote http://forum.linhes.org/viewtopic.php?f=2&t=7200 |
Page 1 of 1 |
| Author: | Zepalesque [ Sat Dec 03, 2005 5:11 pm ] |
| Post subject: | PVR-350 Sound works but not with remote |
Has anyone seen this problem before? I have a PVR-350 and have tweaked just about everything I care about to work - expect that I cannot control the volume using the keyboard or remote control. I do get sound and can control the volume using the television's remote. Just in case the information is relevant, here's my output from lspci: Code: 0000:00:00.0 Host bridge: Intel Corp. 82815 815 Chipset Host Bridge and Memory C
ontroller Hub (rev 02) 0000:00:01.0 PCI bridge: Intel Corp. 82815 815 Chipset AGP Bridge (rev 02) 0000:00:1e.0 PCI bridge: Intel Corp. 82801 PCI Bridge (rev 02) 0000:00:1f.0 ISA bridge: Intel Corp. 82801BA ISA Bridge (LPC) (rev 02) 0000:00:1f.1 IDE interface: Intel Corp. 82801BA IDE U100 (rev 02) 0000:00:1f.2 USB Controller: Intel Corp. 82801BA/BAM USB (Hub #1) (rev 02) 0000:00:1f.3 SMBus: Intel Corp. 82801BA/BAM SMBus (rev 02) 0000:02:09.0 Ethernet controller: 3Com Corporation 3c905C-TX/TX-M [Tornado] (rev 78) 0000:02:0a.0 Multimedia video controller: Internext Compression Inc iTVC15 MPEG- 2 Encoder (rev 01) 0000:02:0b.0 Multimedia audio controller: Ensoniq ES1371 [AudioPCI-97] (rev 09) 0000:02:0c.0 VGA compatible controller: ATI Technologies Inc Radeon RV100 QY [Ra deon 7000/VE] Thanks! |
|
| Author: | stevepugh [ Sat Dec 03, 2005 6:25 pm ] |
| Post subject: | |
If you're using the PVR-350 for your audio output, do you have it looped through your soundcard properly? If you don't, and are piping it directly into your speakers/audio gear, then you won't be able to use Myth controls to adjust volume. There is a checkbox for using the PVR-350's audio out instead of loop-through in Setup/Playback somewhere... Best, Steve |
|
| Author: | ryanpatterson [ Sat Dec 03, 2005 8:01 pm ] |
| Post subject: | |
The audio out from the pvr-350 is a linelevel out. It can not be controled by mythtv. It is always at 100%. However stevepugh just posted if you loop the audio signal through your line-in on your soundcard mythtv can control the level. This will also allow you to get sould from mplayer or xine. |
|
| Author: | Zepalesque [ Sun Dec 04, 2005 2:05 am ] |
| Post subject: | Thanks ! |
Thanks for the info, I appreciate it. Looks like I have to go shopping for a cable tomorrow. |
|
| Page 1 of 1 | All times are UTC - 6 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|