I have an ultraview plus dvb-t card, which apparently is a rebadged DVICO plus card.

Except that it doesn't get detected, on doing some hunting around, i came across this.

How do i actually do this, is it a config file in /etc i edit or is there more to it then that..



Regards Glen

Try adding these lines to /etc/mythtv/modules/bttv

(Got this partially from http://bc.whirlpool.net.au/forum-replie ... 306387&p=2 )

woo hoo, the card now seems to be detected and appears in mythtv..

Now another snag, when i go into mythtv it says all available cards are being used, so i hunted around and found a scan for channels, when i choose to schan for channels, it just sits there doing nothing..

After a while, i get the error "Error tuning to transport"

any ideas?

try the folowing as root

killall mythbackend

then try the scan for channels.

see if that helps

uugh not so much brute force. lets be a bit more gracefull

/etc/init.d/mythtv-backend stop

then when you are done

/etc/init.d/mythtv-backent start

_________________
Have a question search the forum and have a look at the KnoppMythWiki.

Xsecrets