| LinHES Forums http://forum.linhes.org/ |
|
| Installing the mx4000 http://forum.linhes.org/viewtopic.php?f=2&t=8136 |
Page 1 of 1 |
| Author: | nicko1245 [ Fri Jan 27, 2006 5:48 pm ] |
| Post subject: | Installing the mx4000 |
I just order my parts for my knoppmyth setup, and I am wondering if the mx4000 will install the drivers automatically, or do I have to configure it for the s-video out to work? I am going to use my TV as my monitor. I am new at this so any help would be appriecated. Thanks |
|
| Author: | tjc [ Fri Jan 27, 2006 8:01 pm ] |
| Post subject: | |
The KnoppMyth install should automatically install the correct drivers for that card. However, you do need to set up your config file appropriately as described in the installation instructions. http://www.mysettopbox.tv/doc.html or http://www.knoppmythwiki.org/index.php?page=KnoppMythInstall. Searching for "XF86Config-4" here or on the wiki will provide more examples and details. |
|
| Author: | nicko1245 [ Fri Jan 27, 2006 8:18 pm ] |
| Post subject: | |
It says Quote: You will still need to edit /etc/X11/XF86Config-4 to change the refresh rate or you can destroy your TV. Where do I go to configure these settings, and what settings are the best?
Thanks |
|
| Author: | tjc [ Fri Jan 27, 2006 8:55 pm ] |
| Post subject: | |
tjc wrote: Searching for XF86Config-4 here or on the wiki will provide more examples and details.
What's your local video standard? If it's NTSC-M (U.S. or Canada) the FX5200 example on the wiki should be close. Searching for the highlighted word on the wiki would turn that up as the the first or second result. |
|
| Page 1 of 1 | All times are UTC - 6 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|