| LinHES Forums http://forum.linhes.org/ |
|
| Can not Change Channel with PVR 150 http://forum.linhes.org/viewtopic.php?f=2&t=8166 |
Page 1 of 1 |
| Author: | jammad [ Sun Jan 29, 2006 2:07 pm ] |
| Post subject: | Can not Change Channel with PVR 150 |
Hello, this is my first crack at KnoppMyth, and as expected I ran into a little snag. This is basically just a proof of concept before I invest any significan amount of money in decent hardware. I am using R5A30.2 on a Pentium 3 933 Dell 4100 with a Hauppage PVR 150 MCE, 256 Meg of RAM, 40 gig HD, no TV-out (yet). I ran the install and everything seems to be fine, but when I went to watch Live TV I only see Channel 4. I cannot change the channel. I tried changing it from us-cable-hrc to us-cable with no change in results. I can bring up the guide and all the channels show in the list, but again I only see Channel 4 (even though I think the default start Channel is 2. I have a feeling I missed a step somewhere. Does anyone have other suggestions. |
|
| Author: | jammad [ Sun Jan 29, 2006 2:09 pm ] |
| Post subject: | |
Just for clarification I am trying to change channels via the Keyboard. I do not have any remote configured. |
|
| Author: | Xsecrets [ Sun Jan 29, 2006 4:19 pm ] |
| Post subject: | |
on setup input connections did you associate your input (tuner0 for cable) with the appropriate video source? |
|
| Author: | jammad [ Sun Jan 29, 2006 6:52 pm ] |
| Post subject: | |
I think that was it. I ended up re-installing and did the step you mentioned and it worked great. Thanks for the help. |
|
| Page 1 of 1 | All times are UTC - 6 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|