LinHES Forums
http://forum.linhes.org/

Remote working after initial setup, then stops after tweakin
http://forum.linhes.org/viewtopic.php?f=2&t=8345		 Page 1 of 1
Author:  derek585 [ Mon Feb 06, 2006 9:37 pm ]
Post subject:  Remote working after initial setup, then stops after tweakin
Hi all and, first of all, thanks for maintaining such a useful site.

I am at my wit’s end as I have spent more time troubleshooting the remote than all of the other problems combined.

Here is my problem. I am using a homemade IR receiver based on http://www.lirc.org/receivers.html. I set up lirc during the initial setup of Knoppmyth (same as lirc-reconfig.sh) using the Huappage option (16) with remote option Radio Shack (e).

Then I follow the lirc-Howto at http://knoppmythwiki.org/index.php?page=LIRCHowTo, and start at the line
Quote:
vi /etc/init.d/bootmisc.sh
I used an old One For All URC-5060 http://www.hifi-remote.com/ofaold/index.html) universal remote set to VCR code 081. I get some functionality, but this remote does not have all of the buttons that the Radio Shack remote does.

Next I purchased a URC-6131 and used the setup found at http://www.vulturesnest.net/mythtvremote.html I rebooted and there was no response to the remote. Unfortunately, I did not try the new remote before I changed the setup.

So I thought maybe I need to use irrecord to match the code to my setup. I strictly followed the naming convention set up by Joe "The Vulture" as root. Then I overwrote /etc/lircd.conf with the newly created conf file. Still nothing.

So I ran lirc-reconfig.sh to try to change the setup back to the original and reboot. Still nothing!

I did not see any error messages in dmsg regarding lirc. I was unable to find a log file for lirc. My hardware setup is as follows:
AMD 2100+
ASUS A7V333 motherboard with onboard CMI-8738-MC6 audio
nVidia Geforce3 64 MB video
STB PCITV bt848 tv card

There must be something simple I am missing. I am relativley new to Linux and very new to Knoppmyth. Please help!
Author:  derek585 [ Mon Feb 06, 2006 10:07 pm ]
Post subject:  Resolved?
I was troubleshooting and when I used irw, the remote began working! I remember seeing a post regarding intermittent problems. For now I am keeping my fingers crossed!
Author:  derek585 [ Thu Feb 09, 2006 9:28 pm ]
Post subject:  Update
Just an update, in case anyone else has a similar problem. To solve this issue I used lirc-reconfig.sh to overwrite the config files, then I opened them again with pico, and inserted the config file I wanted to use, edited out the unwanted lines, and saved. I had to do this for both lircrc and lircd.conf. I assume it must have had something to do with the DOS encoding of the file I downloaded from the Internet.
Page 1 of 1 All times are UTC - 6 hours
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/