Currently if you have an SATA drive, you must use Manual Install. You will see two options 1. Partition and 2. Quit, on a new drive or a drive with an invalid partition table. If you see six options, KnoppMyth recognizes the partition table. Either way, you must partition the drive. Select partition and create 3 partitions using cfdisk. The first will be /, the second swap, the third /myth. I recommend 5 gigs for /, swap should be 1.5 times memory. Use the rest of the drive for /myth. Ensure /dev/xda1 is bootable, write the partition table and quit cfdisk. Once the partitions have been created, press <CTRL><ALT><F2>. mkswap /dev/xda2 && swapon /dev/xda2. Format /dev/xda3 with the desired filesystem type. Once complete <CTRL><ALT><F1> and return to the installation.

Note: During the making of partitions, you can choose any fstype you wish, ext2 is recommended for the data (xda3).

# mke2fs -j -O sparse_super -m0 -i8000000 -L myth -M /myth /dev/xda3
(I highly recommend a journalling fs for /dev/xda3).


You should now see six option. Choose 4. Load config. You should now see /KNOPPIX/knoppmyth. Press <ENTER>. If you have an SATA drive, change this to /KNOPPIX/knoppmyth-sata and press <ENTER>. Next, choose 1. Configure Installation. Provided the requested information. Don't create a user called "mythtv", this user has already been created with a password of "mythtv". Once back to the main menu, select 2. Start installation. Verify the information and sit back. Once complete, reboot the system. After the system reboots it will start X and KnoppMyth will open an Xterm and ask for the root password. See post installation