If any one here could help me get these cards working simutaniously or at least point me in the direction of getting them working it would be greatly appreciated because i am startin to lose it
(not with just this issue but knoppmyth all together 
) ok well i origianlly had a hd-3000 at first and i could get it to pick up cable channels if i set it to standard vl4 assigned to /video0. Then my pvr-150 came in the mail so i installed it and reinstalled knoppmyth all together because i messed it up any way. Now i cannot get the hd-3000 to configure properly and pick up channels. I was told possibly the pvr-150 loaded a kernel the hd-3000 doesnt agree with. I notice that when i try to setup my hd-3000 as a dvb card it thinks the hd-3000 is /video0 when in fact it is /video1 because with the new install and the pvr-150 coming before it on the mobo the pvr-150 is now video0. i can recieve svideo signal from my scientific atlanta 2200.
system specs:
ABIT KV-85
amd sempron 3100 64bit 1.8
200Gb hard drive
1 gig ram
pvr-150
hd-3000
mx4000