| LinHES Forums http://forum.linhes.org/ |
|
| Xine and Via Epia http://forum.linhes.org/viewtopic.php?f=2&t=9386 |
Page 1 of 1 |
| Author: | madsholme [ Thu Mar 30, 2006 2:11 pm ] |
| Post subject: | Xine and Via Epia |
Hi I tryed to seach on the wiki, but it disent seem to hold any information. Does Xine support the Via Epia mpeg2 decoding chip? if so, how do i enable it? |
|
| Author: | nigelpearson [ Fri Mar 31, 2006 4:01 am ] |
| Post subject: | |
Er, I searched for Xine plus EPIA, and the fifth link I found: http://mysettopbox.tv/phpBB2/viewtopic. ... =xine+epia has what little information there is in this Forum. This page may also help: http://cvs.sourceforge.net/viewcvs.py/x ... ml?rev=1.3 |
|
| Author: | madsholme [ Fri Mar 31, 2006 4:13 am ] |
| Post subject: | |
nigelpearson wrote: Er, I searched for Xine plus EPIA, and the fifth link I found:
http://mysettopbox.tv/phpBB2/viewtopic. ... =xine+epia has what little information there is in this Forum. This page may also help: http://cvs.sourceforge.net/viewcvs.py/x ... ml?rev=1.3 this here dosent work Code: -vo xxmc
but i will try read the other link.. tnx |
|
| Author: | madsholme [ Fri Mar 31, 2006 4:25 am ] |
| Post subject: | |
doing a lsmod dosent revel CLE266 module, and i it dosent seem to be on the system, can that be? if so, how do i install it? i would need CLE266 in order to use the mpeg2 decoder right? |
|
| Page 1 of 1 | All times are UTC - 6 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|