View unanswered posts    View active topics

All times are UTC - 6 hours





Post new topic Reply to topic  [ 1 post ] 
Print view Previous topic   Next topic  
Author Message
Search for:
PostPosted: Sat Feb 09, 2019 3:35 pm 
Offline
Joined: Sat Feb 09, 2019 3:16 pm
Posts: 1
I am in the UK installing LinHES 8.5.2 with a Hauppauge WinTV card to use with FreeSAT. The LinHES 'Channel Scanner' 'Tuning' display shows nothing for signal/noise and signal strength. I did think that I had a cable fault but I have put an analog signal strength meter inline between the card input and the wall socket and set it to 'scream' mode on it's speaker when the signal is good. When LinHES tries a channel scan my little analog meter screams very loudly to acknowledge that there is a good signal on the wire but LinHES says it couldn't find anything. I can tell when LinHes is opening and closing the adapter from the sound of my meter being off, then on during tuning, then off again when the following error is displayed.

Code:
Programmer Error: Failed to handle tune complete


Does someone have a LinHES channel data set for the UK that I can try to import instead?

I have two WinTV cards. The intention is to use both, but for now setup on one. They both give the same error.


Top
 Profile  
 

Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 1 post ] 


All times are UTC - 6 hours




Who is online

Users browsing this forum: No registered users and 5 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Jump to:  
Powered by phpBB® Forum Software © phpBB Group

Theme Created By ceyhansuyu