| LinHES Forums http://forum.linhes.org/ |
|
| Kernal installation fails on VIA mini-ITX board http://forum.linhes.org/viewtopic.php?f=22&t=23675 |
Page 1 of 1 |
| Author: | nicost [ Thu Jan 10, 2013 11:44 pm ] |
| Post subject: | Kernal installation fails on VIA mini-ITX board |
I have been running KnopMyth version R5F27 happily since 2007, but now need to upgrade to add support for a digital tuner (HVR-850). When booting LinHes 7.4 I get the following message: "this kernel requires the following features not present on the cpu cx8 cmov" I gather that at one point in the development of KnopMyth/Linhes some kernel compile flags have changed that make it no longer work on the hardware I have. Does anyone know when this switch took place (hoping that there is a version that supports my new digital tuner)? Is there a way to compile all binaries in the distribution so that they will work on my hardware? Alternatively , does anyone have recommendations for a board with the same (mini-ITX) form factor that does work with the latest LinHes version? Thanks! Nico |
|
| Author: | graysky [ Fri Jan 11, 2013 2:40 pm ] |
| Post subject: | Re: Kernal installation fails on VIA mini-ITX board |
Hardware details? CPU, MB? |
|
| Author: | nicost [ Fri Jan 11, 2013 3:05 pm ] |
| Post subject: | Re: Kernal installation fails on VIA mini-ITX board |
VIA Epia M-series board, probably one of their VIA Eden ESP processors, can check for more details if useful |
|
| Author: | graysky [ Fri Jan 11, 2013 5:18 pm ] |
| Post subject: | Re: Kernal installation fails on VIA mini-ITX board |
nicost wrote: VIA Epia M-series board, probably one of their VIA Eden ESP processors, can check for more details if useful OK... that makes sense. I'm actually surprised that the debian kernel and packages run on your VIA chip. As you know, KM was based on debian unstable and LH is based on Arch. Arch Linux does not run on VIA processors; you have only two flavors: i686 and x86_64. Think you're out of options if you want to use LH but let one of the LH devs comment. |
|
| Author: | jams [ Fri Jan 11, 2013 10:16 pm ] |
| Post subject: | Re: Kernal installation fails on VIA mini-ITX board |
The R6 series is the start of requiring an i686 class cpu and dropping support for 586. The via chip almost makes it, but they didn't fully implement the spec and it's somewhere between a i586 and 686 cpu. |
|
| Author: | mattbatt [ Sat Jan 12, 2013 12:48 am ] |
| Post subject: | Re: Kernal installation fails on VIA mini-ITX board |
I don't know if this helps at all but it sure is long. http://radagast.ca/epia/epia_howto/index.html |
|
| Page 1 of 1 | All times are UTC - 6 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|