| LinHES Forums http://forum.linhes.org/ |
|
| Problems with HD=PVR http://forum.linhes.org/viewtopic.php?f=22&t=23926 |
Page 1 of 1 |
| Author: | jfitzmyer [ Sun Jan 05, 2014 6:17 pm ] |
| Post subject: | Problems with HD=PVR |
New installation from scratch on a new hard drive. I have an Hauppauge HD PVR 1212 connected to a Motorola QIP-6200 on Verizon FIOS using a component cable. I have been using this setup for over 2 years using Mythdora and a firewire change script 6200ch. In my new 8.1 installation, I can not get the STB to change channels. I have spent some time with google and see that a script mythchanger can be used to change channels. I do not have seem to have mythchanger available. There is no /bin/mythvchanger in my system. Using pacman -S mythchanger reports that mythchanger does not exist. I can set the channel change script to /bin/true and watch whatever channel the STB is set to, but I can't change channels. Any suggestions? Thanks! |
|
| Author: | christ [ Sun Jan 05, 2014 11:52 pm ] |
| Post subject: | Re: Problems with HD=PVR |
Google brought it up as the first link: https://wiki.ubuntu.com/majoridiot?acti ... f.beta.tar This is what I use. You may also find: https://code.google.com/p/stb-command/ to be useful. I wrote it to send other (non-channel change) commands to the STB such as power on, off and status check. |
|
| Author: | jfitzmyer [ Sat Jan 18, 2014 10:28 am ] |
| Post subject: | Re: Problems with HD=PVR |
Thanks for the reply! I came across the link you suggested before I posted but somehow I was hoping (maybe naively) there was a built in solution in Linhes. After getting some development tools, I was able to use this link and install mythchanger. Things are working fine now. Thanks! Joe |
|
| Page 1 of 1 | All times are UTC - 6 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|