LinHES Forums http://forum.linhes.org/ |
|
JMicron JMC2XX ethernet issue http://forum.linhes.org/viewtopic.php?f=23&t=24834 |
Page 1 of 1 |
Author: | fr33f411 [ Thu Apr 18, 2019 7:11 pm ] |
Post subject: | JMicron JMC2XX ethernet issue |
My wired ethernet is not working, from the dmesg log: Code: jme: JMicron JMC2XX ethernet driver version 1.0.8 jme 0000:02:00.5 eth0: JMC250 Gigabit Ethernet chiprev:23 pcirev:3 Searching around for a solution it appears an easy solution is to run: Code: ethtool -s eth0 speed 100 duplex full autoneg off If I do that and then run Code: dhcpcd eth0 My ethernet will start working. I was trying to find where I could add this in the startup so it would run automatically. Can anyone point me to the preferred location to add this setup? |
Author: | mattbatt [ Thu Apr 18, 2019 10:12 pm ] |
Post subject: | Re: JMicron JMC2XX ethernet issue |
Have you tried setting up your network card through the GUI yet? From the main menu screen go to Settings LinHES Settings Network (it's the 9th one on the list) and you should be able to setup your network adapter from there. LinHES has system utilities built into the MythTV GUI it's different than most MythTV installations. |
Page 1 of 1 | All times are UTC - 6 hours |
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |